Texas Molecular Capabilities

www.texasmolecular.com

TM Deer Park Services LP (Texas Molecular)

Underground Injection Capabilities

February , 2010


Texas Molecular Underground Injection Capabilities

• Fact Sheet

• General Capabilities

• General Limitations and Restrictions

• Specific Capabilities and Comments

• More Information


Texas Molecular Underground Injection CapabilitiesFact Sheet

• Deer Park Facility (TM Deer Park Services LP)» Over 60,000,000 gallons injected annually» 2 FRP wells to service pH 0-14 without neutralization» Permitted to inject hazardous waste by TCEQ Underground Injection Permits and EPA

“No Migration” exemption.» Permit capacity: approx. 236,000,000 gallons per year» Bulk storage: 1.5 million gallons, 3.4 million gallon permit » Permitted drum storage: 6792 drums » Accept Bulk Truck, Bulk Rail, and Containers» 24/7 Receiving » 24/7 Customer Service» 5 Unloading pads


Texas Molecular Underground InjectionGeneral Capabilities

• Manage Problem Wastewaters» Clean Water Act

Solve discharge or treatment problems No discharges to waterways Saves cost of onsite treatment and Frac tanks

» Land Disposal Restrictions. Met by EPA “No Migration” exemption

» Wide waste code list (D, F, K, U, and P)» Special wastewaters

D001 high organic subcategory D003 reactive sulfides and cyanides D009 high subcategory pH 0 to 14 Pesticides Difficult to treat or discharge water

» Separate solids and phased organics prior to deepwell

Texas Molecular Underground InjectionGeneral Limitations and Restrictions

• No fuming acids

• No radioactive waste

• No infectious wastes

• No waters or wastes with headspace vapors above OSHA PEL

• Limitations on wastes that corrode fiberglass linings and pipe

• Limited waste temperatures above 120 F

• Water that cannot filter at 20:1 dilution or “Batch Press”

• No phased highly toxic organics

• Limitations on emulsions

• Limitations on high molecular weight soluble organics

• Limitations on very low flash point, high vapor pressure wastes

• Limitations on water with Calcium


Texas Molecular Underground Injection Specific Capabilities and Comments

Capabilities• Acids (Hydrochloric, Sulfuric,

Phosphoric, Chromic, etc)

• Nitric Acid (separate system)

• Caustics and high pH

• Sulfides in Liquid (D003)

•Water with metals

•Water with organics at high levels

Comments

• No fuming acids. Acids at most concentrations

• No solids with Nitric Acid

• All concentrations

• Headspace limited to 4.7 ppm

• No regular limitations

•Organics must be soluble or miscible, no emulsions


Texas Molecular Underground InjectionSpecific Capabilities and Comments, continued

Capabilities

•Water with phased organics

•Water with solids

• Incompatible waters

•Water with corrosive organics

• Caustic Sulfides

•Waters with constituents that cannot be discharged

Comments•Organics separated for Fuels

• Solids filtered in filter presses

•May be segregated in own tank, volume permitting

• Accepted to solubility in water or decanted.

• Headspace H2S<10 ppm.

• Routinely managed (no discharge to waterways)


Texas Molecular Underground InjectionSpecific Capabilities and Comments

Capabilities

•Waters with constituents greater than “land ban” standards

Comments

• Routinely managed (Federal EPA “No Migration” exemption)


Texas Molecular Underground InjectionAdditional Questions

• More Information available at www.texasmolecular.com

• Contact Texas Molecular Account Manager

• Contact Texas Molecular Customer Service, 281-930-2540


http://www.texasmolecular.com/

Texas Molecular Capabilities

Documents

Transcript of Texas Molecular Capabilities