For telecommunication installation and maintenance For monitoring security equipment messages For field phone use

Check in seconds whethera DSLAM is connected on a pair

Identify and monitor communicationon unknown pairs fast and easy

Monitor and decode messagestransmitted by security equipment

www.vesala.fi - H. Vesala Oy - Finland Test equipment for telecom and electricity professionals since 1968.

Test Telephone AP32

Test Telephone AP32

SIA TX (1/3)<OK> ->

Alarmsent OK

www.vesala.fi

Test Telephone with ADSL/VDSL indication

Line monitoring and testing features

AP32 is an easy-to-use multipurpose test telephone fortelecom technicians. It has been designed in co-operation withusers to meet their practical daily work requirements. WithAP32, the user does not need to carry several individualdevices. Yet AP32 is compact and inexpensive.

To switch AP32 from telephone to line monitor mode, or fromDSL tester to signal generator mode, just use the simplekeypad shortcuts. The LCD display shows active mode andessential settings all the time with its large characters andinformative symbols.

Communication identifyingCI (communication identification) mode is the basic test modefor monitoring lines without causing interference. It shows theline voltage and possible frequency clearly on LCD and helpsthe technician to define which type of line is at hand, such asPOTS, ISDN, or xDSL.

DSLAM detectionAP32 also includes an unbeatably fast DSLAM test: just pressOK during DSL test and AP32 will tell within a few secondswhether there is an ADSL or VDSL DSLAM on line or not. Nomore waiting with a laptop and modem!

In telephone modes AP32 uses an integrated ADSL/DSL filterto minimize interference to DSL lines.

DSL pair identificationThe DSL test mode is an extended monitor mode for checkingespecially DSL lines. Besides showing voltage and frequency,DSL test makes high frequencies audible, which helps the userto recognize active DSL lines or, for example, to tell whether aDSL modem is sending a handshake signal.

Monitoring security equipment messagingAP32 also supports monitoring of the security messagingprotocols widely used in the security & alarm systems.Supported protocols include SIA® standardized 300 bd FSK("SIA"), Ademco® Contact ID, most common pulse formats andgeneric DTMF of telephone dialling. AP32 can monitor anddisplay both the transmitted messages & data and the receivedhandshakes and acknowledgement signals.More detailed brochure of AP32 security equipment monitoringfeatures can be found on our web site www.vesala.fi.

DSL TEST43kHz 0V

Modemseems to

work

<Tel+data>125kHz +48V

ADSL

DSLAM TESTDSLAM found

DSLAMresponds

Pair testerTest the approx. resistance of apair to find out if the pair isopen, shorted or low-ohmic.

Signali generatorUse the AP32 as a signalgenerator to produce specifiedfrequency between 0.1kHz and99.9kHz on three alternativelevels.

Check line statusSee the line voltage before a calland check that the loop current iswithin limits during a call.

Puhelu! CID:2248920

Ring!

Further features

Monitor diallingIn CI mode monitor all DTMF codessent by a terminal equipment, suchas telephone dialling sequence.

www.vesala.fiTest Telephone AP32

Analogue telephone

Calling over a POTS line with the AP32 is as easy as using amobile phone: Choose a name from the phone book, redial anumber from the redial list, or manually dial a number andpress off-hook. If the AP32 is off, it will wake up to an incomingcall and give a ring tone. Furthermore it will tell the caller IDnumber with DTMF or FSK protocols.

AP32 works as a field phone as well. Using the LB-mode over acold pair is very easy: just connect, press off-hook and and starttalking.

You can even use DTMF tones in LB-mode for testing orprogramming certain equipment.

LB Field phone

There are even more handy features in the AP32 to ease yourwork, for example...

Call...25mA +6V

SIGNALGEN.10.0kHz/0.5V

PAIR TEST100-500Ω

With AP32 I cando also these...

DTMF: 123456

Call... Call...

Want to checkanother pair?

No, thisis enough

Display and keypad Large 2-line alphanumeric LCD with symbols and

backlight. Silicon treated rubber 21 key keypad withtones.

Connectors Line connector: RJ45 (includes interface to pair 1 and

pair 2), Headphone connectors: 2 pcs. 3.5mm stereojack (for 32ohm headphones).

Batteries and power consumption 1 pc. 9V alkaline battery 6LR61 or similar rechargeable

battery. Current consumption 7...32mA.Dimensions and weight ABS, size 179 x 63 x 46mm, weight approx. 290g

including battery.Measurement specifications

DC: -240...+240V, ±1V or 2%AC: 1...240V (peak value), ±2V or 4%.Frequency measurement: 0.1kHz ... 6.5MHz.Signal generator: 0.1kHz...99.9kHz, sine wave,output voltage level (peak) 150mV, 0.5V or 1.5V,current measurement 0...10mAPair test: Resistance ranges <100ohm, 100...500ohmor >500ohm.Security equipment support: SIA®, Ademco ContactID® and pulse messaging formats

Signalling and coding specificationsDTMF output level: selectable -9/-11dBm or -6/-8dBm.

Pulse dialling: Pulse ratio selectable 60/40ms or67/33ms.

CID-receiving: ETSI compatible FSK and DTMFmethod (also TDC specification).

DSLAM-test: According to ITU-T G.994.1.

Basic setup and accessoriesAP32 basic setup

AP32 (telephone)

AP15B (telephone cord, 1.5m RJ45 / 2 x 4mm bananaplugs)

User manual

Main accessories

AP15RJ (telephone cord, 1.5m, RJ45 / RJ12)

HM12 (headphones with microphone)

DPP4 (protective casing)

Various adapters for e.g. LSA-plus terminal blocks,screw terminals etc. are also available

© H. Vesala Ltd. 1904. Contents subject to change without notice.VESALA is a registered trademark of H. Vesala Ltd.

Manufacturer:H.VESALA Oy (Ltd.)Peräsimentie 1, FI-03100 NUMMELA, FINLANDTel. +358 44 200 2005Email: info@vesala.fi Web: www.vesala.fi

Additional information

● AP32 has a standard RJ45 connector which enableschanging test cord easily. The AP15B cord has banana plugswhich allows using various adapters.

● The AP15RJ cord (accessory) fits directly to both RJ11 andRJ45 sockets.

● DPP4 protective case (accessory) protects AP32 from dirtand has a wrist strap.

● AP32 has built-in over-voltage protection mechanisms toprotect the device and minimize interference totelecommunication.

● HM12 headset (accessory) allows hands-free use and makesworking in a noisy environment easier.

● AP32 uses a standard low-cost 9V battery. It has low batteryconsumption and automatic switch-off.

● Software is upgradable, which allows menu language andbasic settings to be customized.

● Furthermore, Vesala offers efficient service and customersupport.

Technical specifications

AP15Bcord

AP15RJcord(accessory)

AP32 andthe DPP4protectivecasing(accessory)

HM12headset(accessory)

Technical specifications

Made in Finland