Technical data rev 02...Master file: Technical data_rev_02.xls 01-09-15 ATEX CONDITION [ Group II ]...
Transcript of Technical data rev 02...Master file: Technical data_rev_02.xls 01-09-15 ATEX CONDITION [ Group II ]...
Nr:Date:Rev_ Date:
A)
# 1
# 2
# 3
# 4
5
B)6
# 7 Pn1 [kW]# 8 Pr1 [kW]
9 n1 [min-1]10
11
C) C2 )
# 12
# 13 i Gear ratio Category: [2=standard / 3=special ]# 14 n2 Output speed [min-1] Atmosphere: [G=gas / D=dust ]# 15 Mr2 Output torque demand [Nm] Zone: [1 - 21 / 2 - 22 ]# 17 fs Service factor required Temperatur class: [ T4 / 135 °C ]
18 Rotation of the output shaft CW CCW # 19 L10H Bearings lifetime [h]# 20 Gears lifetime [h]
21 SFmin Safety for tooth root stress standard reference (ISO preferred)22 SHmin Safety for flank pressure standard reference (ISO preferred)
D)23 Rc2 Radial load on output shaft [N]24 x2 Load application distance from shaft shoulder [mm]25 αRC2 Angle of application of the output Radial load [° ' '']26 Rc1 Radial load on input shaft [N]27 x1 Load application distance from shaft shoulder [mm]28 αRC1 Angle of application of the input Radial load [° ' '']29 An2 Thrust load on output shaft (+ / -) [N]30 An1 Thrust load on input shaft (+ / -) [N]
E )
# 31 Type of application
33 Notes about Duty Cycle:
Duty type
34 vA Ambient air velocity [m/s]# 35 TAMB Ambient temperature range [°C]
36 Altitude a.s.l. [m]37 Rating according FEM class
F )38 Lubrification39 Supplementary cooling systems40 Paint coating41 To specific requests for testing
G )42 Notes and additional Customer requirements:
# 43
H )
[h]# Mandatory for the selection
Date:
T- L- M-
≤ 0.5 > 0.5 ≤ 1.4
S1 S2 S3 S4-S8
Master file: Technical data_rev_02.xls 01-09-15
ATEX CONDITION [ Group II ] - 2014/34/EUGearbox configurationGEARBOX
APPLICATION
UTILITYHours used for Selection
NOTES
OPTIONS OR ADDITIONAL REQUESTS
> 1.4
……..
Time phase
,,,, ,,,,
hours [Nm] [min-1]
+ = push- = pull
32 Duty cycle Time phase
Motor TypeRated motor power
ADDITIONAL LOADS
Gearbox output speed
ELECTRIC MOTOR
,,,, ,,,,
Gearbox output torque
Motor power demand
Pole number
Angle Position
%
GENERAL DATACompany / CustomerContact
TECHNICAL DATA REQUIRED FOR THE SELECTION OF HDP - HDO
Branch / Distributor
,,,, ,,,,
Motor mounting: B3 - B5 - B14
Input speed
Order quantityDelivery time
PLP number if present for Special Gearbox
,,,, ,,,,,,,, ,,,,