T8 TYPE A+B GLASS TUBE
Transcript of T8 TYPE A+B GLASS TUBE
T 8 T Y P E A + B G L A S S T U B E
Aluminum Cap & Plastic Cap
Shatter-proof Coating Optional
VIRTUTECH
LED TUBE
Wattage Length (ft)
CCT(Kelvin)
Luminous flux (lm)
CRI(Ra)
Pack Qty (Pcs)
ItemNumber
Beam Angle Dimming(W) (Degree)
* All data are related to the entire product
For technical information of other CCT, please contact our sales representative.
Due to the special conditions of the manufacturing processes of LED,the typical data of technical parameters can only reflect statistical figures anddo not necessarily correspond to the actual parameters of each single product which could differ from the typical value.
LED Tube T8 High Output
3000 / 4000 / 5000... G13 50,000 H
220°
BEAM ANGLE
T8 LED Tube For Car Parks
*
G=Glass
Version
SYHU
It can be A ,B,C,D
Model Instructions
Company Code Category
T8 =T8 Tube
Materia
AB=Type A+B
DLC Type Length
06=60cm=2ft12=120cm=4ft
Wattage
10=10W12=12W
15=15W18=18W
DiffuserCap Material
XXT8 G AB 06/12 10/12/15/18
T =Transparent“M”=Milky
A =AluminumP=Plastic
CCT
YY30=3000K35=3500K40=4000K45=4500K50=5000K.......
Z
Electrical and Photometric Characteristics*
S Y H U - T 8 G A B B E U L 0 6 1 0 X X - Y Y - Z
VER#:V2.1Revised: 2020-08-17
12 4 >80
15 4 >80
18 4 >80
25
25
25
> 220°
> 220°
> 220°
NO
NO
NO
10 2 3000/3500/4000/4500/50003000/3500/4000/4500/50003000/3500/4000/4500/50003000/3500/4000/4500/50003000/3500/4000/4500/5000
>80 25> 220° NO
SYHU-T8GABBEUL1212XX-YY-Z
SYHU-T8GABBEUL1218XX-YY-Z
SYHU-T8GABBEUL1215XX-YY-Z
SYHU-T8GABBEUL0610XX-YY-Z
Rate Wattage Luminous (lm)
12 12.515 15.818 18.9 2312
ItemNumber
SYHU-T8GABBEUL1212XX-YY-Z
SYHU-T8GABBEUL1218XX-YY-ZSYHU-T8GABBEUL1215XX-YY-Z
(W)10 10.6 1392SYHU-T8GABBEUL0610XX-YY-Z
Ballast Factor(W) 0.78
Ballast Factor(W) 0.88
Ballast Factor(W) 1.1
14.818.2221.28
12.31
16.519.522.1
14.210 10.6
173520882312
13921623
17352088
1623SYHU-T8GABBEUL1210XX-YY-Z 12.31 14.2
IP RatingIP20
Power Factor>0.9
Starting Time<1.0 s
Base TypeG13
Operating Temp.-20°C ~ +45°C
Non-dimmable
Lumen Maintenance50,000Hours
CRI>80
10 4 >80 25> 220° NOSYHU-T8GABBEUL1210XX-YY-Z
Nominal Voltage120V-277V
BE=Both end
Power mode
BE
Certificate
UF=UL +FCC
UL=UL
UL/UF
VIRTUTECH
Phone: +86-752-5331203 Web: www.virtuled.com E-mail: [email protected] | |
Luminous Intensity Distribution Diagram
Maximum overall length (mm) 4ft
8911A
2ft
588B 1205595
C 1213603
Dimension Diagram*
*
T8 LED Tube For Supermarket
2D Light Intensity Distribution Curve
Polar Graph
C Plane: C0.0γ Cone: γ5.0
0
30
60
90
120
150
180
210
240
270
300
330
0.0
87.9
175.8
263.7
351.6
439.5
Plane [50%Ang.] [10%Ang.]
C0.0: 209.5 343.1
4ft 5000K 18W 2100LM
)m(retemaiD)xl(E retneC)m(thgieH
1.0 434.40 -7.594
2.0 108.60 -15.188
3.0 48.27 -22.782
Beam Angle:209.5
CBA
VIRTUTECH
Phone: +86-752-5331203 Web: www.virtuled.com E-mail: [email protected] | |
T8 LED Tube For Industry
Package *
Size
2ft4ft
Qty/Carton
2525
Qty/Pallet
12502500
Container Container(with pallet)20’GP 40’GP 40’HQ 45’HQ
1140023325
20’GP 40’GP 40’HQ 45’HQ
2425049125
3187563875
3977579775
1000020000
2250045000
2287545750
2750055000
Size
2ft4ft
Net Weight/Pcs Gross Weight/CartonSize of CartonLxWxH (mm/in)
625x 195 x 195mm / 24.6”x 7.7”x 7.7”1235 x 195 x 195mm / 48.62”x 7.7”x 7.7”
0.11kg/0.24lbs0.19kg/0.42Ibs
3.3kg/7.26lbs5.64kg/12.43lbs
2ft 4ft100 Cartons 50 Cartons
20
00
mm
1 0 5 0 m m
1 2 6 0 mm
21
27
mm
* Note: The above full container load quantities are based on tube packages foam holders+outer carton.
(* This data Based on the 40’GP)
Package Dimension
Package Information
Pallet Packing Information
≈≈
≈≈
≈≈
≈≈
≈≈
≈≈
≈≈
≈≈
≈≈
VIRTUTECH
Phone: +86-752-5331203 Web: www.virtuled.com E-mail: [email protected] | |
Installation Diagram*
Installation Guide:
1. Turn off the power2. Remove diffuser ( if provided).
(if provided).
1. Turn off the power2. Remove diffuser ( if provided).
Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury.Put led tube in the lig ng fixture.Install the led tubes, close the diffuserTurn on the power.
3.4.5.6.
“Plug” and “Play” procedure
Retrofit Procedure
WARNING
Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury.Cut the wires as shown in the diagram.Make the new wire connect to branch circuit as shown. Replace the cover over the wiring chanel. Install the led tubes, close the diffuser.Turn on the power.
3.4.5.6.7.8.
(UL TypeA)
E479498LISTED
suitable for wet loca on.Direct replacement for 32W*48T8(4 ) fluorescent G13 base lamps.
*
IF US
ING
SINGL
E END
ED
E479498LISTED
suitable for wet loca on.Direct replacement for 32W*48T8(4 ) fluorescent G13 base lamps.
*
IF US
ING
SINGL
E END
EDE479498LISTED
suitable for wet loca on.Direct replacemen or 32W*48T8 (4 ) fluorescent G13 base lamps.
*
IF US
ING
SINGL
E END
ED
E479498LISTED
suitable for wet loca on.Direct replacement for 32W*48T8(4 ) fluorescent G13 base lamps.
*
IF US
ING
SINGL
E END
ED
Before After
1. These lamps should be installed by a licensed electrician.2. These lamps should be used indoors(damp or dry locations only).Not suitable for wet location.3. Make sure tombstones/lampholder are still in good condition and not defected before installation.4. Ensure the brand and model no. of the ballast of replacement tube are in our compatible ballast list.5. Make sure the ballast is working and still under warranty before installation.6. Put LED tubes/G13 pins into right position of the socket, install properly.7. This device is not suitable for using with emergency exits.8. These lamps are not suitable to be used with a light dimmer.If the LED lamp damaged by any one you didn’t comply with above warning. We’ll not responsible for that.
Before
(UL TypeB)
E479498LISTED
suitable for wet loca on.Direct replacemen or 32W*48T8(4 ) fluorescent G13 base lamps.
*
IFU
SIN
GSI
NGL
E EN
DED
C O
E479498LISTED
suitable for wet loca on.Direct replacemen or 32W*48T8(4 ) fluorescent G13 base lamps.
*
IFU
SIN
GSI
NGL
E EN
DED
CO
E479498LISTED
suitable for wet loca on.Direct replacemen or 32W*48T8(4 ) fluorescent G13 base lamps.
*
IFU
SIN
GSI
NGL
E EN
DED
CO
Single End Double End
BeforeE479498LISTED
suitable for wet loca on.Direct replacemen or 32W*48T8(4 ) fluorescent G13 base lamps.
*
IFU
SIN
GSI
NGL
E EN
DED
CO
VIRTUTECH
Phone: +86-752-5331203 Web: www.virtuled.com E-mail: [email protected] | |
Ballast List For T8 LED Tube*
ACCUPROAP-432IP-UNV
ADVANCEIOPA-4P32-LW-N
ESPENVE232MVHIPLEVE232MVHIPEVE432MVHIPEVE432MVHIPLEVE432120HIP
GEGE232MAX-L/Ultra
HalcoEP232IS/L/MV/HE
HOWARD INDUSTRIESEP3/32IS/MV/MC/HE
Pacific FluorescentEB-232IS-120-RES
GE332MAX-N/Ultra
KEYSTONEKTEB-232RIS-1-TP-SLKTEB-232RIS-1-TP-SL/Ga
GE232MAX347-N
OSRAMQHE 2x32T8/UNV ISN-SCQHE 3x32T8/UNV ISN-SCQHE 3x32T8/UNV PSN-SC
GE432MAX347-NGE232-MVPS-NGE332-MVPS-NGE432-MVPS-NGE432-120RESDIYB
PHILIPSICN-2P32-NICN-3P32-NICN-2S40-NIOP-4P32-LW-NIOPA-1P32-NIOPA-4P32-NIOPA-2P32-LW-N
SYLVANIAQHE 1x32T8/UNV ISN-SCQHE 3x32T8/UNV ISL-SCQTP 2x32T8/UNV ISL-SCQT 4X32/120 LP
TRIADB232IUNVHP-NB332IUNVHP-AB432IUNVHP-AB232IUNVHP-B
QT 2x32 T8/347 ISL-SCQHE 4x32T8/347 ISN-SCQHE 4x32T8/347 ISL-SC
UNIVERSALB332IUNVHE-AB432IUNVHE-A
WORK HORSEWH3-120-CWH3-120-L
B232IUNVEL-NB332IUNVEL-AB232IUNVHEH-AB332PUNVHE-AB4321UNVEL-A
IOP-3P32-N
GE-240-RS-MV-NGE232-N-347GE132MAX-H/ULTRA
AP-332IP-UNV-M
VIRTUTECH
Phone: +86-752-5331203 Web: www.virtuled.com E-mail: [email protected] | |
© 2020 Virtutech rights reserved. This document contains information relating to Virtutech product portfolio. Note that the information provided is subject to change. Virtutech does not give any representation or warranty as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance thereon. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract. Virtutech or their respective owners.