Supply Wire Info - EDGEedge.rit.edu/edge/P16602/public/Wk 11 Review/Supply Wire...used mx length of...
Transcript of Supply Wire Info - EDGEedge.rit.edu/edge/P16602/public/Wk 11 Review/Supply Wire...used mx length of...
1
Supply Wire Info P16602: Glass Cutting Machine Wire Supply, Movement and Take-up
Sarah Brown
April 10, 2016
Contents:
Overview
Assumptions for Research/Specifications
Summary of Correspondence
Technical Specification Sheet
Purchase Proposals
Moving Forward
Overview
One of P16602’s main goals is to move and control the wire within an industry-grade glass cutting machine, in order to
test and prove the full functionality of the team’s fixture, wire would eventually need to be purchased. This document
summarizes the research and decisions that went into moving forward with identifying the supply wire to be used for
the glass cutting machine.
Assumptions for Research/Specification
The same diameter of wire that is used on the MB DS264 by Glass Fab, 175 μm steel cord wire was to be used
The same provider of wire that Glass Fab currently uses, Bekaert, would be used as the supplier
The same basic principle of a supply side wire spool that contained x length of wire and a take-up spool that
used mx length of wire (where m is a positive multiplier) would be used as in the MB DS264
The supply wire spool would contain 127 km of wire
The BS80/33 Spool was chosen as the supply wire spool
Designs for the supply wire side mounting systems was designed around the specifications of the BS80/33 Spool
2 Summary of Correspondence
Summary of Email Correspondence with Wire Supplier as of April 10, 2016:
3
4
5
6
7
8
9 Technical Specification Sheet
Wire Spec Sheet provided to team on December 1, 2015:
10
11
12 Purchase Proposals
A summary of the 2 proposals received from Slicing Tech (Bekaert) is provided in the table below along with a copy of
each proposal:
13
14
15 Moving Forward
The team will need to purchase wire in order to test the functionality; proper tensioning, control over
spooling/un-spooling, load/un-load of spools; of the wire movement fixture
A decision with Glass Fab will need to be made as to what quantity of spools the team wants to initially purchase
Reconnect with Rick Baarck at Slicing Tech to redo proposals (proposals were only valid for 30 days)
Work with Rick Baarck to purchase wire
Test the wire movement fixture