CL-13

CLUTCH SYSTEMFLYWHEEL

3. FlywheelA: REMOVAL1) Remove the transmission assembly. 2) Remove the clutch cover and clutch disc. 3) Using the ST, remove the flywheel.ST 498497100 CRANKSHAFT STOPPER

B: INSTALLATION1) Install the flywheel and ST.ST 498497100 CRANKSHAFT STOPPER

2) Tighten the flywheel attaching bolts to the spec-ified torque.

NOTE:Tighten the flywheel installing bolts gradually. Eachbolt should be tightened to the specified torque in acrisscross fashion.

Tightening torque:72 Nm (7.3 kgf-m, 52.8 ft-lb)

3) Install the clutch disc and cover. 4) Install the transmission assembly.

C: INSPECTIONCAUTION:Since this bearing is grease sealed and is of a non-lubrication type, do not wash with gasoline or any solvent.1) Damage of facing and ring gearIf defective, replace the flywheel.

2) Smoothness of rotationRotate the ball bearing applying pressure in thrustdirection.3) If noise or excessive play is noted, replace theflywheel.

(A) Flywheel

CL-00019S T

( A )

CL-00020S T

(A) Flywheel

(B) Ring gear

CL-00021

( 1 )

( 2 )

( 3 )

( 4 )

( 5 )

( 6 )

( 7 )

( 8 )

CL-00022

( B )

( A )