STEPS TO MAKE A PART:

1) Open a new file and click on the top bar then click then click .

2) A 3-plane interface will appear then select a xy-plane for the

sketch and click for sketch.

3) Draw the base of the part with the help of and

commands. Use the command to remove

the extra profile and command to give dimensions.

4) Now use command to exit the workbench.

5) Use command to extrude the profile generated on the sketch workbench. Give the thickness of the

part in the dialogue box. Then click

6) Select the lower surface of the part and click to generate the lower profile.

7) Draw the profile using and commands and

crop the excess profile using and give

dimensions using command.

8) Use the command to extrude the generated profile after exiting the workbench. Put the values required in the pad dialogue box. Then click

.

9) Select the top portion of the part and click to make a point.

10) Click command to draw a point on the surface

of the part and click to give the dimension to

the point from the sides. Then click to exit the workbench.

11) Now select the made point and click command to draw the whole on the point. Give the depth of

the hole and click .

12) Now again select the made point and click command .Now give the hole information of larger diameter and less depth in the dialogue box .And

then click .

13) Now click the side of the part to select the plane

and click .

14) Now draw the profile using and commands

and crop the excess profile using and give

dimensions using command.

15) Use command to make the extrusion of the profile made. Put the values in the dialogue box of

the pad and click .

16) Click the back side of the part and click .

17) Draw the profile using and commands

and crop the excess profile using and give

dimensions using command and then click

.

18) Now select the profile and click to pocket the profile in the part. Give the dimensions in the

dialogue box and click .

19) Select the back side of the plane and click .

20) Draw the profile using and commands

and crop the excess profile using and give

dimensions using command and then click

.

21) Use the command to extrude the drawn profile. Enter the pad value in the dialogue box

and then click .

22) Hence the part is Completed.