STANDARD MATERIAL AND CONSTRUCTION SPECIFICATIONS …
Transcript of STANDARD MATERIAL AND CONSTRUCTION SPECIFICATIONS …
STANDARD MATERIAL
AND CONSTRUCTION SPECIFICATIONS
FOR
PUBLIC IMPROVEMENTS
EAST PENNSBORO TOWNSHIP
CUMBERLAND COUNTY, PENNSYLVANIA
ORIGINAL SPECIFICATIONS AND DETAILS DATED 1995
DETAILS REISSUED JUNE 2020 BY ADDENDUM
East Pennboro Township 8618657 Addendum No. 1
Addendum No. 1
June 9, 2020
STANDARD MATERIAL AND CONSTRUCTION SPECIFICATIONS FOR
PUBLIC IMPROVEMENTS
EAST PENNSBORO TOWNSHIP
Modifications to the Details:
1. REISSUE: all Detail Drawings. Replace existing with the attached Detail Drawings.
END OF ADDENDUM NO. 1
\\ghdnet\ghd\US\Harrisburg\Projects\86\18657\Phase 406_Standard Specifications Update\Draft Details\PDFs\2020-03-04\Table of Contents- Details.doc
EAST PENNSBORO TOWNSHIP STANDARD DETAILS
MANHOLES DETAILS: (MH) MH-1 Heavy Duty Manhole Self-Sealing Frame and Cover MH-2 Heavy Duty Water Tight Manhole Frame and Cover MH-3 Precast Concrete Manhole with Precast Concrete Base MH-4 Precast Concrete Manhole with Precast Concrete Base MH-5 Inside Drop Manhole MH-6 Leveling Rings and Bolted Frame Details MH-7 Manhole Steps MH-8 Poured Concrete Riser for Street Grades of 2% or Greater MH-9 Manhole Pipe Gaskets MH-10 Manhole Section Joint Seal MH-11 Typical Plan of Manhole Channels MH-12 Manhole Pipe Adaptors
TRENCH DETAILS: (TR) TR-1 Trench Backfill Detail in Paved Areas TR-2 Trench Backfill Detail in Unpaved Areas TR-3 Unsuitable Material Excavation TR-4 Bentonite Clay Dam Detail TR-5 Concrete Encasement Detail
SEWER PIPING DETAILS: (SEW) SEW-1 Pipe Reconnection Detail SEW-2 Casing Details for Pipe Boring/Tunnels SEW-3 Steep Slope (Greater than 15%) Sanitary Sewer Detail
BUILDING SEWER/SERVICE LATERAL DETAILS: (LAT) LAT-1 Service Lateral – Shallow Sewer LAT-2 Service Lateral – Deep Sewer LAT-3 Building Sewer LAT-4 Service Lateral Connection to Existing Sewer Main LAT-5 Cleanout/Test Tee Cap Protection Casting LAT-6 Service Lateral Disconnection from Existing Sewer Main LAT-7 Cleanout Location Plan
LOW PRESSURE SANITARY SEWER DETAILS: (LP) LP-1 Typical Grinder Pump Installation Detail - Elevation LP-2 Typical Grinder Pump Installation Detail – Plan LP-3 E-One Grinder Pump StationLP-4 Simplex Sewage Grinder Pump StationLP-5 Typical Electrical LayoutLP-6 Low Pressure Service Line Connection at Gravity/Pressure MainLP-7 Low Pressure Sewer Discharge to ManholeLP-8 In-Line Cleanout /Valve Pit for Low Pressure Sewer MainLP-9 In-Line Terminal Cleanout for Low Pressure Sewer MainLP-10 In-Line Valve Pit Detail Building ServiceLP-11 Curb Stop and Box Detail
\\ghdnet\ghd\US\Harrisburg\Projects\86\18657\Phase 406_Standard Specifications Update\Draft Details\PDFs\2020-03-04\Table of Contents- Details.doc
GREASE INTERCEPTOR DETAILS: (GR) GR-1 Typical Grease Interceptor to Sampling Vault Connection
- Plan and Section
FORCE MAIN DETAILS: (FM) FM-1 Flush Chamber FM-2 Air Release Valve Chamber FM-3 Force main Locator Assembly FM-4 Concrete Thrust Block Details
PUMPING STATION DETAILS: (PS) PS-1 Typical Pump Station Layout
VALVE BOXNEW
ITT GRINNELL FIG. #148ROD WITH EYE END
HEAVY PIPE CLAMPITT GRINNELL FIG. #216
FORCEMAINNEW
TO RODCLIP WIRE
EXISTING GROUND, BLACKTOPOR CONCRETE
MULTISTRAND WIRE
1' MAX.