SQ 1 FINISH ROLLER - Square 1 Design
Transcript of SQ 1 FINISH ROLLER - Square 1 Design
SQ-1 FINISH ROLLER
BR-SQ-FR-1710
• For use on Roof Trusses
• Final pressing of nail plates
• Heavy duty design
• Meets long term demand for continu-ous pressing of plates
• Produces at 119 feet per minute, alter-nate speeds are available
866-647-7771 [email protected] www.Square1Design.com
SIDE VIEW FRONT VIEW
PURPOSE
PROCEDURE • Activate start button
• Rolls will rotate for pressing nail plates
• Roof trusses or Jacks fed from build table
• Will feed trusses to be conveyed for stacking
• Emergency Shut-off on control panel
• Safety shut-off beams/bars or safety scanner located at the truss entrance and exit of the machine for safety
FOOTPRINT
Electrical Specifications
• Horsepower: 15 or 20
• Voltage: Amps
208 60 HZ 40.2
230 60 HZ 36.2
460 60 HZ 18
415 50 HZ 19.8
• E-stop with interlock
• Photo electric sensor e-stops, safety
bar, or safety scanner emergency
stop
• 20 HP motor upgrade
• Rapid change from 1 1/2” to 3 1/2” gap between rolls for floor trusses
• Soft start inverter
• Available in 10’, 12’, 14’, 15’ and 16’ lengths
• Roll height adjustment
• Customizations available
• Solid lubrication
866-647-7771 [email protected] www.Square1Design.com
Mechanical Specifications
• Speed: 119 FPM
• Operators Required: Continuous operation,
• Support: Phone
Onsite ($)
• Weight: 11,500 lbs
• Double row spherical roller bearings
• 24” roll diameter
• 4” stub shaft diameter
• 32” height to top of bottom roll
• Bottom roll height can be set at al-ternate dimensions at time of order
• #80 chain drive system
• Dual Motors
OPTIONS
SPECIFICATIONS
866-647-7771 [email protected] www.Square1Design.com
• Dual motors allows the machine to continue operation upon a motor failure, often al-lowing 90% of normal operations to occur
• Dual motors provides a shorter stopping distance in the event of hazardous situation
• All subcomponents may be sourced locally to ensure minimal downtime
• Customizations available
ADDITIONAL REASONS
TO PURCHASE