SKF Multi-core Induction HeatersA unique and flexible heating solution for very large bearings and workpieces

The patent pending, SKF Multi-core Induction Heaters (TIH MC series) are energy efficient custom-made heating solutions, that can save heating time and potentially reduce CO2 emissions.

Flexible design, consisting of a number • of induction heating cores and coils controlled by a single control and power cabinet. Suitable for heating large thin section • workpieces, such as railway tyres

Depending on workpiece, heating • capacities of several tonnes can be realised.For components sensitive to uneven • induction heating, they allow for a more even temperature gradient across the whole circumferenceErgonomically designed sliding yoke, • for larger TIH MC series, reduces cranage timeRemote control panel, detachable from • the power cabinet, helps improve ease of use and user safety

Temperature mode allows the desired • heating temperature to be specified, helping prevent component overheating. Time mode for heating components • other than bearings, allows flexibility in applicationAutomatic demagnetisation at the end • of heating cycle helps reduce the risk of ferrous contamination of the bearing.Unique design allows for custom-made • solutions to be quickly and economically produced3 year warranty•

Mounting and lubrication

ЗАО "Берг АБ" (495) 727-22-72 promshop- biz@ya.ru www.promshop.biz

www.mapro.skf.com · skf.com/mount · skf.com/lubrication

® SKF is a registered trademark of the SKF Group.

© SKF Group 2009The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permis-sion is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein.

MP/PDS TIHMC EN · December 2009

The type of TIH MC series heater required depends on the application. Based on your application details, SKF can configure a solution to meet your needs. To select the right solution, we need application information such as:

Bearings to be heated: Bearing designation• If new bearing: main dimension • and weight (kg)Required temperature (˚C)• Mounting frequency (once a day / • week / month)

Heater data: Power supply available (V, A and Hz)• Present or considered heating method • (oven, oil bath, ...)

Workpiece other than bearing, e.g. housing, gear, bushing, etc.:

Drawing of workpiece with • dimensions (mm)Weight (kg)• Material of workpiece (steel, cast • iron, etc.)Required temperature (˚C)• Mounting frequency (once a day / • week / month)

For more information on the suitability of SKF TIH MC series heaters for your application or for a quotation, contact you local authorised SKF distributor or SKF office.

ЗАО "Берг АБ" (495) 727-22-72 promshop- biz@ya.ru www.promshop.biz