SITE WATER TREATMENT TANKS
Transcript of SITE WATER TREATMENT TANKS
SITE WATER TREATMENT TANKS
PO Box 1305 Sunnybank Hills QLD 4109 P: 07 3879 6913 E: [email protected]
Dunne & Co Printed: 21/3/19 10:09 AM
Our sediment tanks provide a basic and quick solution for on-site water
Sediment tanks come with an 50mm male camlock inlet. The 100mm uPVC flexible outlet is gravity feed to stormwater or kerb location . The tank is fitted two (2) bottom desludging valves to allow for simple installation and quick and easy desludging operation. Sediment tanks are also supplemented with chemical dosing block to enhance the settling rates, effectively reducing Total Suspended Solids (TSS). Units are available in 5,000 litre and 6,000litre tanks.
Dunne & Co Printed: 21/3/19 10:09 AM
Ideal for the treatment of on-site water containing Heavy Suspended Solids.
The slower the flow the more efficient the tank operates .
TANK DIMENSIONS: 5,000 Litre
6,000 litre
Dunne & Co Printed: 21/3/19 10:09 AM
How it works Site water is pumped into the sediment tank via the 50mm Camlok fitting, a Flocking block is placed in the inlet pipe to mix with the untreated water.
Dunne & Co Printed: 21/3/19 10:09 AM
The internal baffles inside the tank are designed to provide maximum settling time for a continuous flow of water
Figure 2 INTERMEDIATE SETTLEMENT ZONE
Dunne & Co Printed: 21/3/19 10:09 AM
The outlet tank contains 25m2 fabric filter as a final filter medium.
Figure 3 PRE FILTRATION ZONE
Dunne & Co Printed: 21/3/19 10:09 AM
The treated water should tested for turbidity and pH after each rain event prior to dumping.
Figure 4 TREATED WATER DRAINING TO ENVIRONMENT
Dunne & Co Printed: 21/3/19 10:09 AM
Testing and Reporting
Figure 5 THE TREATED WATER IS MEASURED AND RECORDED IN NTU
Dunne & Co Printed: 21/3/19 10:09 AM
Figure 6 THE pH VALUE IS MEASURED AND RECORDED OF THE TREATED WATER