Shuri Castle (1) Instructions

8/9/2019 Shuri Castle (1) Instructions

http://slidepdf.com/reader/full/shuri-castle-1-instructions 1/7

Shuri CastleOkinawa, Japan

Assembly InstructionsMountain fold(dotted line)Make a mountain fold.

Valley fold(dashed and dotted line)Make a valley fold.Scissors line(solid line)Cut along the line.

Cut in line(solid line)Cut along the line.

Glue spot(Red dot)Glue parts with the same number together.

Glue spot(Green dot)Glue within the same part.

Glue spot(Blue dot)Glue to the rear of the other part.

GlueThe glue spot(colored dot)shows where to apply the glue.

Tools and materials

Assembly tip

Caution

Scissors, set square, glue(We recommend stick glue), pencil, usedballpoint pen, toothpicks, tweezers, (useful for handling small parts)

Before gluing, crease the paper along mountain fold and valleyfold lines and make sure rounded sections are nice and stiff.

Glue, scissors and other tools may be dangerous to young childrenso be sure to keep them out of the reach of young children.

View of completed model

Assembly Instructions : Eleven A4 sheets (No. 1 to No. 11)

*Hint: Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.

* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.

* This model was designed for Papercraft and may differ from the original in some respects.

Before starting assembly :Writing the number of each section on its back side before cutting outthe sections is highly recommended.(* This way, you can be sure which section is which even after cutting outthe sections.)

Indicates where sections should be glued together.

[1] Assemble the base.

Shuri Castle (Japan) : Assembly Instructions © Canon Inc. © A&A

http://mexakin-shared.blogspot.com



S hu r i C a s t l e O k i na w a , J a p a n

Shur i Cast leOk inaw a, J a pan

© A & A

C A U T I O N

D o n o t h i t o t h e r p e o p l e w i t h t h e p o i n t e d e d g e s . D o i n g s o c o u l d r e s u l t i n i n j u r y . A d u l t s s h o u l d m a k e s u r e t h a t c h i l d r e n o b s e r v e t h i s c a u t i o n .





[2] Assemble the front entrance to the main hall.

Glue these pieces together along the top of parts and .

Insert parts , , andinto this slot and glue in place.





[3] Assemble the front side of the first floor of the main hall.

Parts to

Glue the rear surfaces of the tabs toparts to in place after insertingthese parts where indicated.

Glue the rear surfaces of the tabs to parts , , , ,

and in place after inserting these parts from the reverse side.Attach part so the horizontal line is on top.


[ ]




[4] Assemble the first floor and the front roof surface of the main hall. Cross-section

Parts ,

Parts ,

Glue at a rightangle.

Glue the rear surfaces of the tabs to parts , , and in place after insertingthe parts from the reverse side.


[ ]




[5] Assemble the rear side of the roof of the main hall.

Glue in place so that thissurface faces outward.

Overhead view


[ ]




[6] Assemble the second-floor roof of the main hall.


[ ]


Shuri Castle (1) Instructions

Documents

Transcript of Shuri Castle (1) Instructions