Setting Probe and Cutting Tool Step 1: Mark an object with ......Setting Probe and Cutting Tool Step...
Transcript of Setting Probe and Cutting Tool Step 1: Mark an object with ......Setting Probe and Cutting Tool Step...
Setting Probe and Cutting Tool
Step 1: Mark an object with a 90 Degree angle with a pen as a reference point. In this
example we used a steel brick. This is for the X axis.
Step 2: Using the probe, make contact with the reference point. This is for the X axis.
Step 3: Hover over the X axis.
Step 4: Press "Probe touch point" to set your probe touch point.
Step 5: Update your probe touch point.
IMPORTANT: After updating a point, whether it is the probe or cutter touch point, the
change will be seen in the following areas.
Step 6: Mark the rim with a pen to use as a reference point to find the Z axis.
Step 7: Use the probe to touch the marked reference point. This is for the Z axis.
Step 8: Hover over the Z axis.
Step 9: Press "Probe touch point" to set your probe touch point.
Step 10: Update probe touch point.
Step 11: Rotate 4 point post so that you are now using the cutting tool.
Step 12: Use the cutting tool to touch the marked reference point. This is for the X
axis.
Step 13: Hover over the X axis.
Step 14: Press "Cutter touch point" to set your probe touch point.
Step15: Update your cutter touch point.
Step 16: Use the cutter to touch the marked reference point. This is for the Z axis.
Step 17: Hover over the Z axis.
Step 18: Press "Cutter touch point" to set your probe touch point.
Step 19: Update your cutter touch point.