Separation and Characterization of Indian and Australian Sandalwood Oils
-
Upload
perkinelmer-inc -
Category
Science
-
view
12 -
download
1
Transcript of Separation and Characterization of Indian and Australian Sandalwood Oils
Introduction
Sandalwood (Santalum album L.) is a desired wooden base note for many fragrances in perfume and other scented products including incense. The major component is alpha-santalol with distilled oil usually containing approximately 50%. The alpha-santalol is a weak odor compound with beta-santalol being the stronger odor
compound more associated with sandalwood oil. Typically the tree is grown for 12 years before the total harvest of trunk, branch and root. There are many related species giving rise to counterfeiting and confusion among consumers.
The yield of the wood will change over time with a transition from beta- to alpha-santalol reported. There are more than 234 compounds1 that have been identified in sandalwood extract to add to the overall experience with ongoing research still identifying others.2 Not all compounds have an odor that contributes to the overall scent and it is possible to identify the tree source by the ratio of compounds present. There is also a synthetic santalone that is available and present in commercial fragrances. The addition of synthetic materials can be somewhat controversial as there is a school of thought that such synthetics take away the magic from a fragrance. The alternative viewpoint is that the synthetic material is not subject to natural disasters or simply weather impacting supply and there are fewer compounds present which may cause allergic reactions.
Separation and Characterization of Indian and Australian Sandalwood Oils
A P P L I C A T I O N B R I E F
Gas Chromatography/ Mass Spectrometry
Authors:
David Scott
PerkinElmer, Inc. Shelton, CT
2
The application of Gas Chromatography-Olfactometry (GCO) and mass spectrometry are considered routine and are frequently the techniques of choice for analyzing extracts from these fragrant woods.
Experimental
Three oil samples were obtained from a commercial aromatic oil source. Separation was achieved with a 60 m wax column for the increased number of theoretical plates, though a shorter 30 m column could also be used for a faster separation. Post column, an S Swafer™ device was used to split the effluent between the SNFR™ olfactometry accessory for olfactometry and the Clarus® SQ8 MS for identification. Due to the sensitivity of the mass spectrometer, the samples were diluted with 1 drop added to 1 mL of methanol.
Two injection techniques were performed. A simple wet needle injection, and headspace (HS) trapping with the TurboMatrix™ HS trap.
The wet needle injection demonstrates the analysis of a distilled oil, and the TurboMatrix headspace (HS) trap describes the possible analysis of wood prior to distillation. No wood samples were available for this work however the excellent trapping efficiency of the TurboMatrix and 22 mL vial size suggests that a representative sample of wood chips could be analyzed prior to distillation.
Needle 210 °C
Oven 190 °C
Transfer Line 210 °C
Trap Low 30 °C
Trap High 350 °C
Vial Pressurization 1 min
Vial Desorb 3 min
Dry Purge 1 min
Trap Hold 5 min
Desorb 0.1 min
Thermostat 25 min
GC Cycle Time 140 min
Carrier Pressure 35 psi
Desorb Pressure 35 psi
Vial Pressure 40 psi
Table 1. TurboMatrix HS110 Trap.
Transfer Line Temperature 200 °C
Source Temperature 180 °C
Mass Range 30 – 300 m/z
Scan Time 0.2 secs
Interscan Delay 0.1 secs
Ionization Mode EI+
Run Time 108 min
Table 3. MS Conditions.
Injectors Both at 250 °C
Oven Program 40 °C (hold 2 min) and ramping 2 °C/min to 240 °C (hold 15 min)
Column 60 m x 0.32 id x 1.0 µm
Table 2. GC Conditions. The Swafer configuration allows manipulation of the column flow rate and separation without impacting the active split between the mass spectrometer and olfactometry port. The split ratios and flows are a result of the selected transfer line geometries and carrier gas pressure. The addition of the second pressure source regulates the splitting and maintains the engineered configuration independent of the column head pressure. The independence from the column head pressure increases the options available to the chemist with respect to flow rate in the separation. The separation is critical from an identification standpoint and for optimum human interaction. It is all too easy for the human to be overwhelmed with multiple peaks and the odors rolling over one another making an accurate description troublesome. Therefore a 60 m x 0.32 id wax column was used starting at 40 ºC and ramping 2 ºC/min to 240 ºC. The full instrument conditions are given in Tables 1 through 3.
Figure 1. Schematic of the separation. For wet needle analysis the headspace system was removed and the capillary injector was used instead.
Figure 2. PerkinElmer SNFR olfactometry accessory.
3
46.00 51.00 56.00 61.00 66.00 71.00 76.00 81.00 86.00 91.00 96.00 101.00 106.00Time0
100
%
Scan E I+
TIC
7.26e9
95.38
56.71 87.06
99.12
95.59
98.38101.02
103.41
Alp
ha-s
anta
lol
Beta
-san
talo
l
Beta
-san
tale
ne
Alp
ha-s
anta
lene
Epi-b
eta-
sant
alen
e
Figure 3. Chromatogram of Indian Sandalwood oil showing the santalene compounds and the large alpha- and beta-santalol content.
46.00 51.00 56.00 61.00 66.00 71.00 76.00 81.00 86.00 91.00 96.00 101.00 106.00Time0
100
%
Scan E I+ TIC
4.18e9
95.20
88.68
79.0973.66 85.37
99.03
95.55
97.51
103.41
101.5899.52
Beta
-saa
ntal
olA
lpha
-san
talo
lBe
rgam
otol
Nuc
ifero
l
Alp
ha-b
isabo
lol
Beta
-bisa
bolo
l
(E)-n
erol
idol
Den
drol
asin
Farn
esol
Figure 4. Chromatogram of Australian Sandalwood oil with the distinctive compounds indicated.
Santalum spicatum (West Australian) and Santalum album (East Indian) sandalwoods. Among the major differences are the higher alpha and beta santalol content in the Indian Sandalwood and the presence of several key components in Australian Sandalwood that are absent or significantly reduced in Indian Sandalwood oil.
It is readily apparent that the Indian Sandalwood has significant alpha- and beta-santalol content but there are other compounds present in the Australian sample that are absent in the Indian oil. The Australian Sandalwood oil has less of the alpha- and beta-santalol but more significant is the increase in several other
compounds that could be considered as indicative of Australian Sandalwood oil. The dendrolasin, (E)-nerolidol, the beta-bisabolol, apha-bisabolol and nuciferol are easily identified as distinct from the Indian Sandalwood.
Results
The compounds present in sandalwood oils are a direct result of the distillation/extraction of the oil from the wood.
A recent patent application3 concerning the therapeutic uses of different sandalwood oils describes the different compositions of
4
23.00 28.00 33.00 38.00 43.00 48.00 53.00 58.00 63.00 68.00 73.00 78.00 83.00 88.00 93.00 98.00 103.00 108.00 113.00Time0
100
%
Scan E I+ TIC
5.99e8
95.10
50.74
25.4137.32 47.22
88.6283.59
79.0963.8953.12 80.35
97.90103.41
100.02 109.86104.16
Lim
onen
e
Lina
lyla
ceta
te
Isob
orny
lace
tate
Isol
ongi
fole
ne Ben
zyl b
enzo
ate
Die
thyl
pht
hala
te
Figure 5. Chromatogram of Sandlewood oil showing the synthetic ester compounds and lack of alpha- and beta-santalol.
47.00 51.00 55.00 59.00 63.00 67.00 71.00 75.00 79.00 83.00 87.00 91.00 95.00Time0
100
%
0
100
%
Scan E I+ TIC
5.59e9
Scan E I+ TIC
5.59e9
Alpha-longipineneBeta-himachalene
Beta-curcumene
Alpha-curcumene
Teresantalol
Figure 6. Chromatograms of Indian and Australian Sandalwood oil with TurboMatrix HS-Trap to elucidate small differences in the two samples.
Analysis of the third oil sample gave strong indications that the sample was not an authentic sandalwood oil.
The presence of several synthetic esters and diethyl phthalate to fix them in the oil is strongly suggestive that the "sandlewood" sample is not an oil distilled from a species of Santalum. The isolongofolene and the benzyl benzoate are both woody tones that have been used to mimic the sandalwood experience. The limonene would appear to have been added to balance out the tones.
The common components are easily identified with a wet needle experiment and the TurboMatrix HS Trap was used to increase the sample volume without solvent column overloading. Four microliters of the sample were then injected into a headspace vial for a total evaporation experiment. The increased mass on column assists in the identification of smaller peaks and further highlights the differences in the two sandalwood species.
For a complete listing of our global offices, visit www.perkinelmer.com/ContactUs
Copyright ©2015, PerkinElmer, Inc. All rights reserved. PerkinElmer® is a registered trademark of PerkinElmer, Inc. All other trademarks are the property of their respective owners. 012021_01 PKI
PerkinElmer, Inc. 940 Winter Street Waltham, MA 02451 USA P: (800) 762-4000 or (+1) 203-925-4602www.perkinelmer.com
Conclusion
The GCO system discussed successfully separated alpha- and beta- santalol in two commercially obtained sandalwood samples. Qualitative differences were identified demonstrating the capability of adulterant recognition. There is still active research in identifying new scents from botanical sources making GC-olfactometry an important tool in the quest for new sources of fragrance as well as preventing adulteration and counterfeiting.
References
1. N. Baldovini et al., Flavour Fragr. J. 2011, 26, 7–26
2. T. Hasagewa et al., Flavour Fragr. J. 2011, 26, 98–100
3. Ian Clements, Paul Castella, Corey Levenson, Application number PCT/US2011/026706, 2011.