Select-Info Packet Power, Power Meter With Mesh Wi-Fi Data Transmission

1

Click here to load reader

description

Collects power consumption data from any device and sends alerts by e-mail or SMS Detects other smart power cables and automatically form a wireless network Add or remove a smart power cable and the system automatically adapts Captures detailed, time-stamped data on amps, volts, watts, watt/hours, volt-amps reactive, power factor, frequency, spikes and Sags Supports single, two and three phase power in 110 to 240 VAC, 50 to 60 Hz, and 10 to 2,400 amps. Maintains key data during power and communications disruptions Fail-safe design, will not disrupt the flow of power Flexible, web-based reporting and alerts by e-mail and SMS Interfaces to other monitoring applications in TXT, HTML, CSV, XML or SNMP formats Cloud-based data analysis service for rapid installation and minimal ongoing support requirements Map power readings to facility layout diagram Access real time information, create historical reports and export to CSV file Create and publish dashboards and QR labels Requires just one Ethernet port and IP address Optional Smart environmental monitors to record detailed temperature and humidity in real time Specifications: - Operating frequency From 860 to 930MHz. - Wireless protocol Proprietary frequency hopping, self-configuring, load balancing mesh network - Wired network protocol TCP/IP (one IP address needed per Gateway), SNMP interface with support for traps - Firmware updates Wireless over the air - Typical transmission range 10 to 50 meters indoors from any one device to any other - Antenna Fully enclosed, fixed configuration - Cable to Gateway ratio, Up to 300 cables per gateway - Unlimited gateways per site with multi-site support - Encryption Optional 128-bit

Transcript of Select-Info Packet Power, Power Meter With Mesh Wi-Fi Data Transmission

Page 1: Select-Info Packet Power, Power Meter With Mesh Wi-Fi Data Transmission

Captures detailed, time-stamped data on amps, volts, watts, watt/hours, volt-amps reactive, power factor, frequency, spikes and Sags

Supports single, two and three phase power in 110 to 240 VAC, 50 to 60 Hz, and 10 to 2,400 amps. Maintains key data during power and communications disruptions Fail-safe design, will not disrupt the flow of power Flexible, web-based reporting and alerts by e-mail and SMS Interfaces to other monitoring applications in TXT, HTML, CSV, XML or SNMP formats Cloud-based data analysis service for rapid installation and minimal ongoing support requirements Map power readings to facility layout diagram Access real time information, create historical reports and export to CSV file Create and publish dashboards and QR labels Requires just one Ethernet port and IP address Optional Smart environmental monitors to record detailed temperature and humidity in real time

Specifications:

- Operating frequency From 860 to 930MHz. - Wireless protocol Proprietary frequency hopping, self-configuring, load balancing mesh network - Wired network protocol TCP/IP (one IP address needed per Gateway), SNMP interface with support for traps - Firmware updates Wireless over the air - Typical transmission range 10 to 50 meters indoors from any one device to any other - Antenna Fully enclosed, fixed configuration - Cable to Gateway ratio, Up to 300 cables per gateway - Unlimited gateways per site with multi-site support - Encryption Optional 128-bit

Lyan Center, 1st floor, Ashrafieh, Beirut Tel/Fax: +961 (0)1 42 35 35 / 42 37 37 [email protected] www.select-info.net

Power Meter With Mesh Wi-Fi Data Transmission Collects power consumption data from any device and sends alerts by e-mail or SMS

Detects other smart power cables and automatically form a wireless network Add or remove a smart power cable and the system automatically adapts

Mesh Ethernet Gateway 1,2,3 phase industrial plug Smart power cord Smart panel up to 2,400 Amp