0 cm 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

0 cm 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

1 : 1 1 : 1 Clockwork Printable Scale Ruler www.clockworkprint.com.au

0 m 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

1 : 100 1: 100 Clockwork Printable Scale Ruler www.clockworkprint.com.au

0 m 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 210 220 230 240 250 260 270 280

0 m 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 210 220 230 240 250 260 270 280

1 : 1000 1: 1000 Clockwork Printable Scale Ruler www.clockworkprint.com.au

0 cm10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 210 220 230 240 250 260 270 280

0 cm10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170 180 190 200 210 220 230 240 250 260 270 280 1 : 10 1 : 10 Clockwork Printable Scale Ruler www.clockworkprint.com.au

0 m 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Architectural Scale Rulers for Plan and Map Measurement

Printing InstructionsWhen printing a ruler please ensure “Fit to Page” settings are off. You must print these rulers at 100% otherwise the scale measure-ment will not be accurate. Printing process can vary from machine to machine so please do not rely on the ruler unless it’s been validated.

Validating your Printed RulerTo validate this ruler locate the 1 centimetre validation measure in the centre coloured strip of each ruler and use an existing calibrated ruler to measure it. If the validation measure equals exactly 1 cm then the printed rulers are validated.

Please read the disclaimer available at http://www.clockworkprint.com.au/client_tools/printable_scale_rulers.html prior to use.