Runwise Operator Training

Introduction

Name: Nicholas Barnett

Place of Birth: Pasadena, MD

Occupation: Hybrid Technical Specialist

Phone Number: 410-935-6037

Parker HDS Call Center: 866-858-5600

Operator Training Overview

Objectives

1. System Overview

2. Safety Features

3. Towing Procedures

4. Pre Trip Inspection

5. Vehicle Start up Procedure

6. Running the Vehicle

7. Shift Pad and Gear Selection Display

Warning Labels

Brake Energy Recovery Bypass

1. When the ignition switch is shut off

2. The vehicle is near a complete stop

3. The accumulators reach their maximum

state of charge

4. During heavy brake applications

5. ABS event

6. Hybrid Drive System Fault

Check Hybrid Light Stop Hybrid Light

1. Ensure that the parking brake is applied

2. Ensure the ignition switch is in the off

position

3. Turn the battery disconnect switch to

the ON position and ensure the air brake

valves are closed

4. Turn the Ignition key to the IGN position

5. Ensure the vehicle is in neutral and that

no fault codes are active

6. Start the Engine

Vehicle Start up Procedure

Gauge Assembly

Gear Selection

PDU Temp Gauge

Running the Vehicle

Runwise Hydraulic Oil

Temperature Gauge

Brake Aggression Gauge

Running the Vehicle

State of Charge Gauge

1. Both rear drive shafts have to

be removed prior to towing the

vehicle

2. Follow normal protocol during

a fluid spill

3. Follow normal protocol to

jump start a vehicle

Disabling Procedures

Questions?