Rotary Smart Angle Sensor RHSS-22 -...
Transcript of Rotary Smart Angle Sensor RHSS-22 -...
12 bit resolution 24 or 5Vinput and 0 to 3.3Vdc/5Vdc/10Vdc/4 to 20mA/0 to 20mA Analog Output.24 or 5 or 3.3Vinput and Redundant (Dual) Output 0 to 5Vdc.24 or 5 or 3.3Vinput and PWM Output.24 or 5 or 3.3Vinput and Quadrature Output (AB or ABI)
14 bit resolution24 or 5 or 3.3Vinput and SPI along with PWM Output.24 or 5 or 3.3Vinput and I2C along with PWM Output.
Incremetnal PPR output along (Contactless Knob)( with detent switch available)With Inbuilt Micro controller(Programmed or unprogrammed) as per requirement.
Sleeve bushing, Servo Mount, Flange Mount and Ball Bearing versions.Some variants have a facility to be programmed at user end. All variants with Stopper/ without stopper available.Connectors or Fly wire available.IP 69k Protection available.
The Rotary Smart Angle Sensor is used to detect the angle or speed of system which correspondence to the rotary motion of the shaft of the sensor. In built Signal conditioner facility makes it a unique product in the market.
The Output signal correspondence to 0 to 360deg. This full range is programmable based on requirement and based on the need of the
Since the Product is based on Contactless MagneticTechnology it has very long life.
For modern microcontrollers RHS-22 is capable to give output in 0 to 3.3Vdc, 0-10Vdc, 4-20mA, Quadrature, SPI, I2C, PPR and PWM output version is available.
Wide range of Mechanical and electrical variant makes it a versatile product in the industry.
BUSH MOUNT
SERVO MOUNT
Variants
12-Ichcha Estate, Abrama, Valsad-396001. Gujarat. INDIA.www.potentiometer.co.in // [email protected]
Tel : +91-2632-227780 mob: +91-9998700754
POT-TECH Electronics(Bombay) Pvt. Ltd.
RHSS-22
Rotary Smart Angle Sensor
Mechanical
parameters Ball Bearing Sleeve Bushing
Starting Torque 3 gms cm 150 gms cm
Maximul Radial Load 900 gms 470 gms
Maximum Axial Load Nil Nil
Maximum Shaft Speed 1500 RPM 100 RPM
Bearing Life cycles 500 X 10^6 @rated radial Load 200 X 10^6 @rated radial Load
Weight of sensor 25 gms 25 gms
Shaft Dia 2.95mm 3.15mm or 6 mm or 6.3 mm
Threading 32 TPI3/8 ME
Pilot diameter formounting.
3 Pin screwConnector.
109,6
1,511
9
8
22
10,32
6,3
1,5 1,5 1,5
15
10,7
181922
Unika Make. CE approved 4 core Shielded Cable.Brown: Input VoltageGreen: GNDWhite: Output 1Black: Output 2
Bush Mounting
For Detailed Drawing on Sensor with Flange Mount Facility Please drop a E-mail on [email protected]
For Customize sensor with inbuilt micro controller version Please drop a E-mail on [email protected]
For SPI, I2C and incremental Output only Fly wire version is available.
Shaft Customization is possible.
Tight Motion of shaft is possible.
Servo Mounting
Shaft dia can be 3mm, 6mm, 1/8inch or 1/4 inch
12-Ichcha Estate, Abrama, Valsad-396001. Gujarat. INDIA.www.potentiometer.co.in // [email protected]
Tel : +91-2632-227780 mob: +91-9998700754
POT-TECH Electronics(Bombay) Pvt. Ltd.
RHSS-22
Rotary Smart Angle Sensor
The RHSS22-635SPI is a Absolute encoder which acts as a slave and communicate with master micro controller as per the standard Protocol of SPI.
RHSS22-635SPI communicate in 16 Bit of Transmission.
As per standard protocol of SPI RHSS22-635SPI communicate with master protocol when the MOSI pin is active high or 3FFF hex data is sent on the bus and the CS pin need to toggle from low to high for only one clock pulse.
After each cycle of communication it is compulsory to toggle CS pin from high to low.
RHSS22-635SPI has a provision of Dual Output first SPI communication and PWM mode of communication 14 Bit and 12 Bit of Resolution respectively.
Number of sensors can be connected in daisy chain mode of 4 wire or (n+3 wire connection). please contact Mr. Pavan Kinariwala for more information on the same.([email protected])
RHSS22-635SPI will communicate the angle information in below pattern.
Parameters Results
Input Voltage (Vinp) 6 to 35Vdc / 5Vdc / 3.3Vdc
Maximum clock Frequency 50k Hz.
Digital pin Input / output level including address pins.VDD- 5Vdc (Vinp --> 6 to 35Vdc or 5Vdc)VDD- 3.3Vdc (Vinp --> 3.3Vdc)
1 --> VDD (5V or 3.3V) -0.7V0 --> GND +0.4V
PWM Frequency 1 Khz.
RHSS22-635SPIuC
MISO
CLKCS
MOSI
MISO
CLKCS
RHSS22-635SPIuC
MOSI
MISO
CLKCS
MOSI
MISO
CLKCS
3FFF 1
3 wire connection4 wire connection
Angle information pattern N
ot u
sed
Not u
sed
14 bit resolution angle information
LS
B
MS
B
X X X X X X X X X X X X X X X X
Serial Peripheral Interface
12-Ichcha Estate, Abrama, Valsad-396001. Gujarat. INDIA.www.potentiometer.co.in // [email protected]
Tel : +91-2632-227780 mob: +91-9998700754
POT-TECH Electronics(Bombay) Pvt. Ltd.
RHSS-22
Rotary Smart Angle Sensor
Wiring connection
Red Input (Vsupply)
Green GND
Yellow MISO
BLUE MOSI
Grey CS
White CLK
Magnetic Cross Talk
Mounting
Material
Environment
For best performance of RHSS22 below points needs to be taken into consideration. 1) The hole in the panel should not be more than 9.5mm. 2) RHSS22 should be mounted with Star washer given along with the product and perpendicularity between the panel and axis of Sensor should be maintained. 3) For RHSS22_servo mount model mounting clamps EMC 22 are available.
If two RHSS-22 units are to be installed closer than 4 inch (measured between the center of both shafts), a magnetic shield, such as a small steel plate should be installed in between to prevent one encoder fromcaus ing sma l l changes i n r epo r t ed pos i t i on t h rough magne t i c f i e l d c ross - t a l k .
Component Material
Housing Brass (endless)PBT (with stop or endless)
Shaft Stainless
Ball Bearing Stainless
Parameter Value
Operating Temperature -40 to 75 deg (standard)-40 to 140 deg ( on request)
Storage Temperature -40 to 75 degC
Vibration 20g.
Ordering Information
RHSS22 - I/p Voltage - Output range or type - angle - direction - shaft dia - XXX Any specific Info 5 - 5Vdc 24 - For 24Vdc 360 for endless CW (default) 6 - 6mm dia conn - connector 635 - For 6 to 35Vdc else specify CCW 6.3 - 6.3mm dia cab - cable 3.15 - 3.15mm dia 3 - 3mm dia
For Example: RHS22-635010-360-CW-6-conn
12-Ichcha Estate, Abrama, Valsad-396001. Gujarat. INDIA.www.potentiometer.co.in // [email protected]
Tel : +91-2632-227780 mob: +91-9998700754
POT-TECH Electronics(Bombay) Pvt. Ltd.
RHSS-22
Rotary Smart Angle Sensor
Variants
Brass Metal housing version
PBT housing With Without stop. Along with Gain Offset trim
pots.
Flange mounting version
12-Ichcha Estate, Abrama, Valsad-396001. Gujarat. INDIA.www.potentiometer.co.in // [email protected]
Tel : +91-2632-227780 mob: +91-9998700754
POT-TECH Electronics(Bombay) Pvt. Ltd.
RHSS-22
Rotary Smart Angle Sensor
SERVO MOUNT