RFP Workshop Stockholm 9-11 / 10 / 2008 High Density Limit in RFP’s M Valisa and the RFX-mod team.
-
Upload
michael-barrett -
Category
Documents
-
view
212 -
download
0
Transcript of RFP Workshop Stockholm 9-11 / 10 / 2008 High Density Limit in RFP’s M Valisa and the RFX-mod team.
RFP Workshop Stockholm 9-11 / 10 / 2008
High Density Limit in RFP’sM Valisa and the RFX-mod team
RFP Workshop Stockholm 9-11 / 10 / 2008
OUTLINE
Background on density limit in RFP’s
New RFX-mod experimental results
Discussion
RFP Workshop Stockholm 9-11 / 10 / 2008
• Why are we interested in High Density plasmas?
In a reactor P_fusion ~ ne2 (provided T is around 10 keV)
In RFX E ~ ne
The density limit is a commonality of all of the magnetic configurations .
RFP Workshop Stockholm 9-11 / 10 / 2008
Upper Density Limit in RFP’s known since many years
Costa,De Angelis, Ortolani Puiatti, Nuc. Fusion 22, 1301 (1982). Radiation limit
Ortolani & Rostagni 1983 Nucl. Instrum. Meth 207 35 Radiation limit around n/nG= 0.5 (I/N=2)
Perkins & Hulse 1985 Phys. Fluids 28 1837
Bartiromo et al 2000 27th EPS Conf. Budapest
http://epsppd.epfl.ch/Buda/pdf/p4_031.pdf
Published in M. Greenwald’s review PPCF 2002
•MST density limited regimes ( Wyman’s Thesis 2007)
•Rencent work : Puiatti et al Submitted to PoP Puiatti et al IAEA Conf 2008 Geneve
•Valisa et al IAEA Conf 2004 Villamoura
•Valisa et al IAEA Conf 2006 Chengdu
RFP Workshop Stockholm 9-11 / 10 / 2008
* RFX-Mod
RFP and Tokamak share the same limit•The Greenwald limit is an empirical law
• The Greenwald threshold is not an absolute limit but provides values in the right range
•In Tokamaks nG can be exceeded by a factor 2 by peaking the density profile. Some ITER scenarios assume n/nG ~ 1.2
RFP Workshop Stockholm 9-11 / 10 / 2008
JET
Predicted pedestal DL (detachment)
and Experimental
In JET a pedestal DL is found
overlap
Borrass NF 2004 752
and is worse than the Greenwald limit
RFP Workshop Stockholm 9-11 / 10 / 2008
Stellarator : Sudo limit , much higher than nG
RFX
RFP Workshop Stockholm 9-11 / 10 / 2008
In LHD the critical edge density that leads to complete detachment is well reproduced by the Sudo scaling with a factor 0.8.
Pellet-fuelled plasmas with large density peaking factor Ne(0)/neSudo up to 7 !
Core density can be increased until the core plasma locally collapses,as long as the edge density is kept below the Sudo scaling.
Stellarators: Sudo Scaling
The Sudo scaling is an edge density limit scaling. The operational limit is ne_edge< neSudo
J. Miyazawa . Nucl Fus 2008 and EPS 2008
RFP Workshop Stockholm 9-11 / 10 / 2008
New RFX-mod data
New current regime
Old RFX space
Greenwald limit
Runaway region
RFP Workshop Stockholm 9-11 / 10 / 2008
New on RFX-mod
Confirmed the difficulty to keep the current derivative = 0 at high density
Normalized Current derivativevs n/nG
RFP Workshop Stockholm 9-11 / 10 / 2008
Radiation pattern: a MARFE-like structure
Toroidally localized , poloidally symmetric belt
RFP Workshop Stockholm 9-11 / 10 / 2008
New experiments with induced rotation of a strong artificial m=0 n=1 mode for a “3D” diagnostic of the relevant structures
RFX-mod: DL experiments with induced m=o modes rotation
RFP Workshop Stockholm 9-11 / 10 / 2008
• At the same relative position with respect to the Locked Mode (90 ° apart where the plasma shrinks):• the radiating belt develops • edge density accumulates due to the flow stagnation point ( and low diffusivity.
Instead at the LM (m=1 modes) : Strong H signal= main particle source,
edge flowdisplacement due to m=0
radiation
electron density
Hm=1
toroidal angle
plasma shrinking
induced m=o modes rotation
(Normalized to the Locked mode position)
Locked mode position
RFP Workshop Stockholm 9-11 / 10 / 2008
New . Reconstruction of local flux structure
Poincaré plot.
Region where large radiation belts develop.The relationship between specific m=0 islands and radiaon belts still unclear.
Measurements of Flow and radial electric field reversal are consistent. Possible explanation: the pattern of m=0 islands conveys the electron parallel flow to the wall in certain regions only. ( Carraro et al JNM 2003) (Bartiromo, Phys. Plasmas 5, 3342 (1998)
Magenta line: toroidal flux function.
m=0 islands develop around the reversal surface ( green line).
RFP Workshop Stockholm 9-11 / 10 / 2008
Edge Diffusivity is low with increasing n/nG
Diffusion coefficient estimated from turbulence plotted as a function of normalized density This confirms old RFX measurements (Gregoratto et al NF 96)..
RFP Workshop Stockholm 9-11 / 10 / 2008
(open dots) Prad=Pohm as a function of n=nG;
m = 1 mode normalized amplitude vs n=nG: Squares : low-n modes n = 7 ¡ 9), Dots: high-n modes (n = 10 ¡ 18).
Prad/P_input ratio LOCALLY very high
(full dots) Prad=Pohm taking into account the fraction of input power impinging on the toroidal portion of the radiating layer
Radiating layers tend to manifest and grow beyond the dashed line
RFP Workshop Stockholm 9-11 / 10 / 2008
In the ULq case, appraoching and slightly exceeding the Greenwald limit is quite simple with flat current waveforms.
The ULq case
Well sustained current.
RFP Workshop Stockholm 9-11 / 10 / 2008
Summary of the RFX-mod experimental evidence
With induced rotation of artificially produced modes
At high density in the vicinity of m=0 modes ( not of the m=1 locked mode ) the composition of the radial Er procures a stagnation point for the toroidal flow
Diffusion is sufficiently low to allow local density increase favoured by the RFP topology ( around the reversal parallel flow has no or little toroidal component)
Density ( not necessarily impurity ) accumulation causes radiation to locally build up
At high density localized radiation dissipation is experimenatlly comparable to the power flow to that region possibility of a thermal instability.
RFP Workshop Stockholm 9-11 / 10 / 2008
Question
What in absence of artificially induced m=0 modes (i.e. pure Clean Mode Control) ?
1) Fast TV images (1 kHz) show PWI patterns rapidly changing in space
2) 1D Simulation can be made to check the RFP response to an increase density in an axi-symmetric topology
• MST is more m=0 stable. Experiments could clarify the role of m=0 modes
• In RFX shallow F experiments at high desnity will be performed
RFP Workshop Stockholm 9-11 / 10 / 2008
1D Simulation of high density discharge ( Riport code)
“Riport” code: - 1D ( cilindrical symmetry – does not include 3D effects of plasma deformations - Heat and particle equations ( including impurities solved self-consistentlywith Spitzer resistivity and -dynamo term
See Predebon et al submitted to PoP
RFP Workshop Stockholm 9-11 / 10 / 2008
Simulated RFP discharge with a linearly increasing influx
1D Simulation od high density discharge ( Report code)
Increased resistivity causes the current to decrease unless the dynamo term is proportionally augmented
RFP Workshop Stockholm 9-11 / 10 / 2008
Conclusions 1
• New experimental evidence in RFX—mod confirms that localized radiation belts develop in the region where m=0 islands are formed.
• The evolution is favoured by converging toroidal flow of particles and low edge diffusivity.
• ULq reaches quite easily the Greenwald DL with well sustained current ( despite general transport is worse) .NB: In ULq’s the m=0 resonance is no longer in the plasma
In RFX-mod best performance is with QSH which is instead prefers regimes at high Lundquist ~ Te3/2/ ne1/2We must learn how to to make QSH and high ne compatible..
RFP Workshop Stockholm 9-11 / 10 / 2008
Conclusions 2
In Tokamak , Stellarators and RFP’s exceeding a density threshold triggers some kind of instability processes at the egde: typically involving radiation cooling.at the edge (except TEXT : DL due to transport change.D. Brower et al PRL 67, 200 (1991) )
In Tokamaks MARFE structures can lead to a disruption.
In the Stellarator and in the RFP (including ULq) the consequences are not disruptive
In the RFP current sustainement becomes critical even before nG is reached unlike the ULq
The density limit is originated by similar physics , but modulated by the topological and stability properties of each configuration.
RFP Workshop Stockholm 9-11 / 10 / 2008
Conclusions 3
Questions:
• Would an m=0 controlled RFP plasma avoid the Greenwald density limit?
• Is the RFP intrinsically limited in density due to its topology and the need of an internal dynamo?
• In Tokamaks and Stellarators average densities well above the “DL” have been achieved.Can we conceive a high density RFP with peaked profiles and sufficiently low edge density to overcome the Greenwald limit?Try with internal fuelling (pellet/ power beams )& edge recycling control