Rev. A Control Number XXXXXXXXXXX Effective Date 10/2/2008 Field Work Instructions for Placard...

Rev. A Control NumberXXXXXXXXXXX

Effective Date10/2/2008

Field Work Instructions for Placard replacement Functional Trainer

Page1/4

Revised Date10/2/2008

Approved byBill Baier

Prepared byGreg Virgin

1. Loosen screws holding all upper and lower cross member bars in the machine using an 8mm Allen wrench. Fig. A

2. Remove screws holding upper cross member above placard and set to the side. Fig. B

3. Placard assembly may now be lifted from the machine. Fig. C

4. Be sure to elevate placard when laying down to prevent damage to the accessory hooks. Fig D Fig. A

Fig. B

Fig. C

Fig. D




Page2/4




5. Remove bottom retaining cap using 8mm Allen wrench. Fig. E & F

6. Slide plastic side rails out the bottom of the placard assembly. Fig. G & H

7. Using a 4mm Allen wrench and an 8mm open end wrench, the accessory hooks can all be removed from the placard. Fig. I

Fig. E

Fig. F

Fig. G

Fig. H

Fig. I




Page3/4




5. Remove new placard from packaging, and place old placard along with the accessory hooks and hardware into package for return to Matrix Fitness Systems

6. Install accessory hooks to new placard, install plastic side rails, and bottom retaining cap (reversing steps 5, 6, and 7).

7. New placard can then be set into place on machine. *Warning* Be sure roller bearing and washer are set in place on lower support post before setting placard assembly on it! Fig. J, K & L

8. Re-install top cross member using 8mm Allen wrench. Tighten all other cross member screws that were loosened during step1.

9. Completed placard should appear as pictured. Fig. M

Fig. J

Fig. K

Fig. L

Fig. M




Page3/4




Figure below shows all hardware included with replacement placard.

Rev. A Control Number XXXXXXXXXXX Effective Date 10/2/2008 Field Work Instructions for Placard...

Documents

Transcript of Rev. A Control Number XXXXXXXXXXX Effective Date 10/2/2008 Field Work Instructions for Placard...