160 01 W70

PAGE

MATERIAL SAFETY DATA SHEETCHEMISTRY: SYNTHETIC ALKYD RESINPRODUCT: MSDS-DALKYD 160 01 W70Date Revision: 20/9/2011

Revision: No. 1

Issued by: FirmaApprovated by:Firma

Sandra M. Leclerc G.Alberto Cattaneo

MULTIQUIMICA DOMINICANA, S.A.

P. O. Box 21435

Calle N esquina L Zona Industrial de Hana

San Cristbal, Dominican Republic

In case of emergency:

(809) 542-2721, Fax # : (809) 957-20771.- Product identification:Product name:Dalkyd 160 01 W70

Product class: Synthetic resin solution

HMIS rating: Health = 1 Fire = 2 Reactivity = 0

2.- Composition:Ingredients

Cas #

Maximum content

Soybean oil

8001-30-7

44 %

Phtalic Anhydride

85-44-9

19 %

Pentaerythritol

115-77-5

7 %

White spirit

64742-88-7

30 %

3.- Physical and Chemical Properties:

Physical state:

Viscous liquid

Color:

Amber

Odor:

Aliphatic Solvent

Solidification point:

N/A

Boiling point:

(281 a 285) C

Flash point:

44 C

Ignition temperature:

250 C

Explosion limits:

N/A

Water solubility:

None

Density:

(0.960 0.966) g/cm at 25 C

Vapor pressure:

Inferior to 15 milibar at 20 C

Viscosity:

(Z2 Z4) Gardner-Holdt at 25 C

Acid index:

(5 10) mg KOH / g4.- Fire and explosion hazard data:

Flammability class: 3 DIN 53213

Flash point:

44 C (111.2 F)

LEL:

1.1

4.1 Extinguishing media:

Foam, dry chemical, carbon dioxide or any class B extinguishing agent. Water may be unsuitable as an extinguishing medium, but helpful in keeping adjacent containers cold.

4.2 Special firefighting procedures:

Firefighters and others exposed to vapors or products of combustion should wear self-contained breathing apparatus.4.3 Unusual fire & explosion hazards:

Vapors may form an explosive mixture in air. Close containers may rupture when exposed to extreme heat.

5.- Health hazard data:

5.1 Effects of overexposure:

Skin: This material may cause irritation skin. Prolonged or repeated contact may cause dermatitis.

Eyes: This material may be an eye irritant. Laboratory animals exposed to high doses of Mineral Spirits showed evidence of effects in the liver, kidney, lungs, spleen, heart and adrenals. Rats exposed to White Spirits vapor during pregnancy showed embryo/fetotoxic effects.

5.2 First aid:

Skin: Wash with soap and water immediately.

Eyes: Flush with large quantities of water for 15 minutes and seek medical attention.

Ingestion: If ingested, do not induce vomiting and get immediate medical attention. Aspiration of material into lungs can cause chemical pneumonitis which can be fatal.Inhalation: Move victim to ventilated area immediately. If coughing, difficult breathing or any other respiratory symptoms develop, seek medical attention at once.

5.3 Primary routes of entry:

Inhalation

Skin Contact

5.4 Carcinogenicity: This product does not contain 0.1% or more of any substance listed as a carcinogen by IARC, NTP, or OSHA.

6.- Reactivity data:

6.1 Stability:

Stable.

6.2 Hazardous polymerization:

Will not occur.

6.3 Incompatibility:

Avoid contact with strong oxidizing agents.

6.4 Conditions to avoid:

Warm storage and ignition sources.

Hazardous Decomposition Products:

Incomplete combustion can yield carbon monoxide and toxic vapors.

7.- Spill or leak procedures:

7.1 Steps to be taken in case of material release or spilled:

Remove all sources of ignition. Ventilate area. Absorb spill with an absorbent material such as sawdust, to eliminate focus of possible ignition, and place material into a closed container. Wear protective equipment during cleanup.

If large spillage occurs, dike area to prevent this material from entering water systems or sewers. Warn authorities and residents of affected zones of fire and explosion danger. Prevent contamination of soil, vegetation and subterranean water.7.2 Waste disposal method:

This material has been tested and found to have a flash point below 250 C. If discarted, this material and containers should be treated as hazardous wastes.8.- Special protection information:

8.1 Respiratory protection:

A canister type respirator must be worn to prevent the inhalation of vapors or spray mists when the TLV or PEL is exceeded.

8.2 Ventilation:

General ventilation is required during normal use. Local ventilation may be required during certain operations to keep exposure level below the limits.

Protective Gloves

Chemical resistant nitrile, neoprene or rubber gloves required.

8.2 Eye protection:

Wear protective clothing to prevent skin contact.

Eye wash station and safety shower should be available.

Incomplete combustion can yield carbon monoxide and toxic vapors.

9.- Special Precautions:

9.1 Precautions to be taken in handling and storaging:

Avoid prolonged or repeated inhalation of heated vapors or spray mists. Keep away from heat or open flame. Avoid prolonged or repeated skin contact.

None other precautions. Excessive exposure to vapors or spray mists can result in headache, dizziness, incoordination, nausea and loss of consciousness. 10.- Transport information:

10.1 Land transport (ADR/RID)

ADR/RID class:

Flammable liquid

Danger code (kemler):

30

UN number:

1866

Packaging group:

III

Hazard label:

3

10.2 Maritime transport (IMDG)

IMDG class:

3

UN number:

1866

Hazard label:

3

Packaging group:

III

EMS number:

F-E, S-E

Marine pollutant:

No

10.3 Air transport (ICAO-TI and IATA-DGR)ICAO-TI/IATA-DGR class:

3

UN number:

1866

Hazard label:

3

Packaging group:

III

Proper shipping name:

Alkyd resin solution

The information stated in this Safety Data Sheet, is given without warranty, license, inducement of any kind. This information is accurate to the best of Multiqumica Dominicana, S. A. knowledge, or obtained from sources believed by Multiqumica Dominicana, S. A., to be accurate, and Multiqumica Dominicana does not assume any legal responsibility for use or reliance upon sane. Customers are encouraged to conduct their own tests.