Replicas Locations (2)
-
Upload
pinto-carlos -
Category
Documents
-
view
9 -
download
2
description
Transcript of Replicas Locations (2)
![Page 1: Replicas Locations (2)](https://reader035.fdocuments.in/reader035/viewer/2022080222/563dbbff550346aa9ab05e02/html5/thumbnails/1.jpg)
Micrographic examination by replicas CNIM suggests to carry out a micrographic examination by replicas on weak points and on other area and compare the results. Below the weak points: - between the connection shell furnace / boiler and the first nozzle (1) - near the connection between boiler and outlet gas chamber (2)
This picture is an extract of the first report we sent you. We select theses points because : Point 1: We are going to weld the cone of the furnace shell so a micrographic examination by replicas will confirm there is no weakness. Point 2: We are going to design some modifications to reinforce this area so a micrographic examination by replicas will confirm there is no weakness. It would be interesting to compare the results obtained for theses points with a micrographic examination by replicas of a third point located in an area without overstress.
1
2
3