1: Parental Guidance is suggested for children operating Helicopter.2: Multiple Helicopters operating simultaneously must be on different Frequency Bands.

• Be sure that Helicopter Battery is fully charged and Remote Control Batteries are fresh.• Helicopter will fly best in low wind conditions. • Fly Helicopter in a wide open area with no people, pets, and other objects in the way.• Do not fly in strong winds. This will make operation difficult and crash the Helicopter.

UP DOWN

FORWARD BACKWARD

ROTATE LEFT

If the Helicopter is rotatingon its own, slowly adjust the Trim Control Knob

Switch betweenHigh Speed & Low SpeedModes

Switch LEDLight Modes

ROTATE RIGHT

HERCULESNANO

3.5 Channel IR Helicopter

ITEM NO. 35939

• Unscrew cover and install 6x AA Batteries as shown.• Please note polarity and orientation of batteries.

REMOTE CONTROL TRANSMITTER HELICOPTER TAKEOFF ADJUSTMENTS

FLIGHT CONTROLS

CHARGING

TROUBLESHOOTING

PREFLIGHT CONDITIONS

BATTERY INSTALLATION

1: Place Helicopter on a flat surface. Turn on the Transmitter and the Helicopter 2: Check surroundings to be sure that it is clear of people, animals, and obstructions.3: Slowly push the Throttle Stick up to increase blade speed for lift.4: Adjust throttle input to maintain a steady hover.

The Left and Right Sticks will move the helicopter as follows:

1: Helicopter can be charged from: USB, Controller, or AC Charger2: Move the Helicopter Power Switch to the OFF position 3: Connect Charging Adapter to Helicopter Charge Port.4: Once charging is complete, disconnect Charging Plug from Helicopter.5: Helicopter is ready for flight.

USB CONTROLLER AC CHARGER

The Transmitter indicator LED does not work

No controlof the helicopter

Helicopter isnot flying highenough

Batteries installed with the wrong polarity.

Point Transmitter at Helicopter or operate in conditionswith less sunlight.

Helicopter is not IR receiving signal fromtransmitter.

Test the control functions of the helicopter in a hover by applying light throttle and testing left and right controls.

Helicopter is not receiving signal fromtransmitter correctly.

Push Left Control Stick up for more rotor speed.Rotor speed is too slow.

Fully charge helicopter before use.Batteries are drained.

Fly helicopter in calm conditions. Windy Conditions.

Check the polarity of the batteries and install themCorrectly.

Batteries are drained. Install new batteries.

AGES 8+

1. Power Indicator LED2. Power Switch3. Throttle Control Stick4. Channel Selector5. Rudder Control Stick6. Trim Adjustment Knob 7. Infrared Emitter8. Throttle Speed Regulator9. LED Light Control

Website: www.worldtechtoys.comEmail: customerserv@worldtechtoys.comPhone: (877) 498-8697 Monday - Friday / 9:00AM - 5:00PM / Pacific Time

WWW.WORLDTECHTOYS.COM

MADE IN CHINA

SPECIFICATIONS, COLORS AND CONTENT MAY VARY FROM ILLUSTRATIONS

ATTENTIONREAD THESE INSTRUCTIONS BEFORE OPERATING THE HELICOPTER

- Install only new batteries of the same type in your product.

- Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak.

- Do not mix old and new batteries.

- Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.

- Do not dispose of batteries in fire.

- Batteries should be recycled or disposed of as per state and local guidelines.

BATTERY CHARGING INDICATORS:

RED light on USB charger will turn on when plugged in and is not charging the helicopter. Red light will turn off when the helicopter battery is charging.

When charging from the remote, the power/charge indicator LED light will turn yellow when charging. The light will turn RED when the helicopter is fully charged.

USB CHARGER

POWER SWITCH

CHARGING PORT