Rear Bumper Removal - N-FAB12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281)...
Transcript of Rear Bumper Removal - N-FAB12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281)...
12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325
PART NUMBER: T14RBS-H PRODUCT: REAR BUMPER/HITCH APPLICATION: 14-17 TOYOTA TUNDRA
Rear Bumper Removal:
Hardware: Qty M8 x 25mm hex bolt 2
M8 washers 4
M8 Nuts 2
1’x1/2” Hex bolts 4
½” nuts 4
½” Washers 8
Parts Included: Qty RBS-H Bumper 1
Bumper Bracket 2
Bracket spacers 4
Step 1: Unplug the connector that connects the bumper’s wiring harness
to the rest of the vehicle.
Step 2: Unplug the connecter on the back of the trailer light plug. Pres the two metal tabs together and push it out of the front of bumper.
.
Step 3: Remove the license plate bulbs from there housing and secure up out of the way.
Step 5: Remove the plastic end cap. (Both sides)
Step 4: Unbolt and remove the license plate and plastic retainer from the
OE rear bumper.
12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325
PART NUMBER: T14RBS-H PRODUCT: REAR BUMPER/HITCH APPLICATION: 14-17 TOYOTA TUNDRA
Step 6: Remove the plastic bumper cap and set aside.
Step 7: Remove the four top bolts and two lower bolts that attach the bumper end and Remove. (Both sides)
RBS-H Bumper Bracket Install:
Step 1: Remove the two 19mm hitch bolts. (Both Sides)
Step 2: Remove the two bolts that attach the OE bumper bracket and remove (Bothe sides))
Bottom
12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 - Fax (281) 880-6325
PART NUMBER: T14RBS-H PRODUCT: REAR BUMPER/HITCH APPLICATION: 14-17 TOYOTA TUNDRA
RBS-H Bumper Install:
OE Bracket will not be re-used
Step 3: Using the two 21mm hitch bolts removed in step 1 and the supplied M8x25mm Hex bolt, nut and washers, install the bumper brackets with the spacers and tighten. (Both Sides)
Passenger Side
shown
Bracket spacers
Step 1: Remove RBS-H bumper skid plate and set aside. Next, install the RBS-H bumper to the
bumper brackets using the supplied ½”x1” hex bolts, nuts and washers.
Step 2: After proper alignment, tighten all hardware. NOTE: Carefully open tail gate to check
clearance with bumper before final tightening.
Step 3: Re-Install RBS-H skid plate and secure. NOTE: An aftermarket license plate light is
recommended.