Raspberry Pi 3 5. 6. 7.d360wfgz11cs0l.cloudfront.net/AstroBox-Quick-Start-Guide.pdfRaspberry Pi 3...
Transcript of Raspberry Pi 3 5. 6. 7.d360wfgz11cs0l.cloudfront.net/AstroBox-Quick-Start-Guide.pdfRaspberry Pi 3...
1. Raspberry Pi 32. WiFi dongle3. Pre-flashed 8 GB microSD card4. Power Supply for the Pi 35. Case for the Pi 36.6. AstroBox stickers7. A dash of love from the AstroPrint Team
5
2
34
1
4 Power up your AstroBox by plugging in the included power adapter.
Power Up1 Assemble
2 Insert the included microSD card into the microSD slot on the side shown in the image below.
Onboard
Plug in the included WiFi dongle into any of the 4 USB ports.
3 Plug In
9 Get printing, then tell all your awesome friends about AstroPrint!
Launch!
CONNECTED ERROR
8 Systems Check
7 Follow the steps in the setup wizard to complete setting up your AstroBox.
Prepare to Launch
You’re About to Change the way you 3D Print Forever!
6 Make Contact
5 Using your phone, tablet, or computer, search for wifi networks. Join the AstroBox wifi network. This shouldn’t take long, but in some cases may take a minute or two.
Open Communications