8/11/2019 Ramps Manual

1/12

8/11/2019 Ramps Manual

2/122

WWW.GADGETS3D.COM WWW.GADGETS3D.EU

8/11/2019 Ramps Manual

3/123

RAMPS 1.4

Unpack RAMPS box (RAMPS 1.4 + arduino + sd shield);

8/11/2019 Ramps Manual

4/124

Take motor wires and solder the same colors from wires with connector and use tape to protect the connection,this will apply to X, Y and E motors;

connector wires motor wires

black yellow

green blue

red red

blue green

8/11/2019 Ramps Manual

5/12

8/11/2019 Ramps Manual

6/126

Take endstop connector and place it;

Thermistor connectors should go near endstop pins;

8/11/2019 Ramps Manual

7/127

Take motor connector and connect it near drivers;

Take flat screwdriver to loose power connector then connect power wires;

8/11/2019 Ramps Manual

8/128

With the same screwdriver loose hotend connectorthen connect wires, after this operation tighten thescrews;

8/11/2019 Ramps Manual

9/12

8/11/2019 Ramps Manual

10/1210

Use flat screwdriver to undermine the A4988 stepmotor drivers,

Additional RAMPS disassembly

8/11/2019 Ramps Manual

11/1211

Use the same tool to deatach arduino module from RAMPS, after this unplug power socket;

8/11/2019 Ramps Manual

12/12