Quick Start Guide For OBDLink SX - OBD Scanner | Car driver link for your operating system and is...

Quick Start Guide For OBDLink SX - OBD Scanner | Car driver link for your operating system and is just a click away: install the ... general information about OBD-II, and ... OBD TM page 1
download Quick Start Guide For OBDLink SX - OBD Scanner | Car driver link for your operating system and is just a click away: install the ... general information about OBD-II, and ... OBD TM

of 1

  • date post

    02-Apr-2018
  • Category

    Documents

  • view

    214
  • download

    2

Embed Size (px)

Transcript of Quick Start Guide For OBDLink SX - OBD Scanner | Car driver link for your operating system and is...

  • AB

    computer

    1. Install drivers 2. Connect scan tool to the PC 5. Install OBDwiz software

    Insert the software CD in your CD-ROM drive. If the drivers were successfully installed, the Click on OBDwiz, and follow the prompts to The scan tool selection menu will automatically status light should turn yellow when you connect install the software:appear. Click on OBDLink SX: OBDLink SX to your PCs USB port (step ). Red

    status light indicates that USB drivers were not installed properly.

    6. Launch OBDwiz software

    To launch the software, click on Startg ProgramsgOBDwizgOBDwiz. The license key can be found on the CD case. Click the Auto 3. Locate the diagnostic connectorDetect button, then click the Connect button.

    Technical support

    The software selection menu will appear. Click on Should you run into problems, technical support the driver link for your operating system and is just a click away:install the drivers:

    Knowledgebase - contains answers to the most commonly asked questions, general information about OBD-II, and troubleshooting information.

    Forum - allows you to share information 4. Connect scan tool to the DLCand get support from other OBDLink SX

    Turn the vehicles ignition to the Key On, Engine users.Off position and connect OBDLink SX to the

    These resources can be accessed from our diagnostic connector (step ). The status light website: should turn green. Yellow status light means no power on DLC; check fuses.

    If the menu does not appear, click StartgRun, type D:\setup.exe (where D is the drive letter of your CD-ROM drive), and click OK.

    A

    B

    The 16-pin D-shaped diagnostic link connector (DLC) should be located in the passenger or driver's compartment in the area bounded by the driver's end of the instrument panel to 300 mm (~1 ft) beyond the vehicle centerline, attached to the instrument panel and easy to access from the driver's seat. The preferred location is between the steering column and the vehicle centerline.

    www.ScanTool.net

    USB cablescan tool

    OBDOBDOBDTM

    Quick Start

    vehicle

    Page 1Page 2