QUALCOMM PROPRIETARY QUALCOMM Corporate R & D1 Performance of VoIP Services over 3GPP WCDMA Networks...
-
Upload
godfrey-blair -
Category
Documents
-
view
233 -
download
2
Transcript of QUALCOMM PROPRIETARY QUALCOMM Corporate R & D1 Performance of VoIP Services over 3GPP WCDMA Networks...
QUALCOMM PROPRIETARYQUALCOMM Corporate R & D 1
Performance of VoIP Services over 3GPP WCDMA Networks
Ozcan OzturkQualcomm
QUALCOMM Corporate R & D
WCDMA Voice Evolution
• The goal is to compare the WCDMA system capacity for Release 99 voice and Release 6 and 7VoIP by using simulations.
• Only the radio link performance is considered here.
• Release 99 uses Circuit Switched (CS) Voice (Dedicated Channels)
• Release 5-6 provides new features for VoIP– Smaller TTIs and H-ARQ on both Downlink (DL) and Uplink (UL)
– Lower overhead on DL (F-DPCH instead of A-DPCH)
• Release 7 introduces additional features for VoIP efficiency– CPC (DTX/DRX): Allows transmitting the pilot only during packet activity
– Enhanced F-DPCH: Reduces code and power usage on DL even further
– HS-SCCH’less mode: Provides savings in HS-SCCH code and power
• VoIP capacity is UL limited in most scenarios. UL Interference Cancellation (IC) provides significant capacity gain by enabling the system operate at higher interference levels.
2
QUALCOMM Corporate R & D
Simulation Framework
• Simulation model is based on 3GPP TR 25.896 specifications
• 57 hexagonal cells (19 Node Bs) with wrap-around
• Inter-Site-Distance: 1000m
• Users (UEs) are dropped uniformly in each cell• Each UE is assigned a channel of PA3, PB3,VA30,VA120 with probabilities
0.3,0.3,0.2,0.2, respectively.
• TTI: 2ms [10ms], max number of transmission attempts: 5 [2]
• Number of HARQ interlaces: 8 for TTI=2ms, 4 for TTI=10ms
• Rake receiver with dual receiver diversity at Node B.
• Both Rake and Equalizer w/ and w/o receiver diversity at the UE
• DTX Cycle: 8 TTIs for TTI=2ms and 2TTIs for TTI=10ms
• HSDPA Power Overhead: 30%
• CQI Feedback Cycle : 16ms
• Channel estimation errors are modeled
3
QUALCOMM Corporate R & D
AMR 12.2 VoIP Traffic Source Model
• Exponential ON-OFF with 50% Voice Activity
• 3 seconds of average Talk Spurt and Silence durations
• A Full Frame (244 bits) is generated every 20ms during Talk Spurt
• A SID Frame (39 bits) is generated every 160ms during Silence
• Header Overheads– 12 bits RTP payload header
– 3 bytes of ROHC (RTP/UDP/IP) header
– 1 byte of RLC header
• Transmitted Packet Sizes (with MAC headers, padding and CRC)– Full Frame
• HSUPA 2ms: 331 bits
• HSUPA 10ms: 341 bits
• HSDPA: 341 bits
– SID Frame
• HSUPA: 144 bits
• HSDPA: 161 bits
QUALCOMM Corporate R & D
System Capacity Criteria
• One way Radio Link delay bound: 100 ms– VoIP frames delayed in excess of this bound are dropped at both Node B and UE
• Downlink capacity– Capacity defined as max number of users where users in outage are less than 5%
– Outage defined by UE’s vocoder frame error rate above 3%• Packet discard at Node B due to delay (100 ms)
• Late packet arrival to UE (i.e., beyond 100ms)
• Physical layer packet errors
• Uplink capacity– Noise Rise outage happens when the Noise Rise over 7dB is more than 1%
– Frame Error Rate (FER) outage happens when more than 5% UEs have more than 3% FER due to physical layer errors or delay bound drops
• Overall system capacity determination– The minimum of Downlink and Uplink capacities
QUALCOMM Corporate R & D
Uplink Interference Cancellation (IC)
• The amount of energy to be cancelled is determined by the Ec/Nt measured.
• At every slot, the pilot energy is canceled for each user.
• At every TTI, HSDPCCH is canceled if active.
• At every TTI, a decoding attempt is made for a continuing packet transmission. If successful, the energy of EDPDCH and EDPCCH over the HARQ interlace is subtracted from the cell Io immediately (also from the other cells in the same Node B if there is softer-handoff).
• Users are grouped according to the retransmission attempts. Each group is decoded and cancelled together (using the same waveform).
• The groups are visited in the decreasing order of retransmission attempts and this is repeated twice.
QUALCOMM Corporate R & D
System Capacity Comparison
7
• Rx Diversity assumed• Release 6 and 7 use 2ms UL TTI• Release 6 uses FDPCH• Release 7 uses DTX, E-FDPCH, HS-SCCH-Less
175%
QUALCOMM Corporate R & D
Release 99 Voice Capacity
DownlinkUplink1Rx
Rake1Rx Equalizer
2Rx Rake and Equalizer
AMR12.2
51 63 70 69
8
• The system is power limited on the DL with single Rx antenna and DL is the bottleneck for the capacity
• Due to the code limitation with receive diversity, the Rake and Equalizer capacities are equal on DL.
• Equalizer gain is not significant since the spreading factor is large (SF=128)
QUALCOMM Corporate R & D
Release 6 and 7 Uplink VoIP Capacity
9
Rel. 6 Rel. 6 w/ IC
Rel. 7 Rel. 7 w/ IC
TTI=2ms 103 136 136 190
TTI=10ms 95 126 106 142
• In all cases, the system is interference limited
•VoIP capacity is higher for TTI of 2ms than 10ms. The difference is even more for Release 7 where most of the gain of the 2ms over 10ms comes from DTX.
• IC provides more than 30% capacity gain
QUALCOMM Corporate R & D
Release 6 and 7 Downlink VoIP Capacity
10
Rel. 6Rake
Rel. 7Rake
Rel. 7Equalizer
1 Rx 61 65 83
2 Rx 101 172 232
• Receiver diversity provides significant power savings which translates to capacity gain.
• The gain of Rel. 7 over Rel. 6 is limited for 1 Rx. This is mostly due to PA3 which is a single path fading channel. The gain of equalizer in this case is limited too.
• For both capacity and coverage improvements, receiver diversity is the preferred option with VoIP.
QUALCOMM Corporate R & D
Packet Delay
11
60 70 80 90 100 110 120 1300
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.9
1
Combined uplink and downlink packet delay
CD
F
CDF of 98th percentile delay for 190 UEs/cell
• The figure shows the combined uplink and downlink over the air delay at the system capacity.
• This was obtained by summing up the uplink and downlink delays.
• Most of the delay happens on the uplink
The 98% of the total delay is plotted to capture the effect of the de-jitter buffer. The graph shows that the total radio-link delay will satisfy the ITU recommendations for a satisfactory voice call.
QUALCOMM Corporate R & D
Mixed Data and Voice
12
Downlink BE Application Layer Throughput vs VoIP Load
0
500000
1000000
1500000
2000000
2500000
3000000
3500000
4000000
4500000
5000000
0 20 40 60 80 100 120 140 160 180 200 220 240
VoIP users
Th
rou
hg
pu
t BP
S
RAKE, Rx Div, A-DPCH,
Equalizer, Rx Div, A-DPCH,
RAKE, Rx Div, F-DPCH,
Equalizer, Rx Div, F-DPCH,
Release 99 Voice
• BE traffic is generated by Full Buffer source.
• Scheduler is Proportional Fair for BE.
• Scheduler gives higher priority to delayed VoIP users.
• A-DPCH code and power consumption reduces the BE throughput.
QUALCOMM Corporate R & D
Conclusions
• 3GPP Release 6 and 7 VoIP provides significant capacity gains over Release 99 Voice
• Uplink IC improves the system capacity and performance even further.
• At the VoIP capacity limited by the uplink, substantial best effort traffic can be served on the downlink.
• On the uplink, the capacity improvements of VoIP are mainly due to:– Time diversity gain by the use of HARQ
– DTX features which reduce the total transmitted power and interference
– Interference Cancellation
• On the downlink, the high VoIP capacities obtained in Release 7 can be attributed mainly to the use of:– Delay and channel sensitive MAC-hs scheduling and resource allocation
– The use of F-DPCH channel
– The presence of advanced receivers (diversity, equalizers) at the UE
13