QR X800(Controlled by DEVO-F12E) Firmware V1.1 Released
-
Upload
husni-mubarak -
Category
Documents
-
view
13 -
download
5
description
Transcript of QR X800(Controlled by DEVO-F12E) Firmware V1.1 Released
Date Version history Bin
2014‐7‐21 QR X800 software V1.1 released X800_1_1
Upgrade notes:
1.MINI USB cable is required.
2. This upgrade is special for QR X800 controlled by DEVO‐F12E radio (receiver must be RX706)
realizing the telemetry function .
Steps::
1. Pls download required files from here :
http://www.walkera.com/en/showgoods.php?id=2290
2. Insert MINI USB cable into below figured port;
Copter: QR X800
Radio: DEVO‐F12E
Version:V1.1
3.Search for your firmware at pop‐up window, see screen as below:
4. choose “Install from a list or specific location(Advanced)”and then Next for Step 4
3, Search for your file route and Press “Browse” on pop‐up window;
4, Press “Next”
Installation drive program interface will be showed.
Completing the Found New Hardware Wizard” appears and then click “Finish”
Upgrade Steps:
1.Press downloaded and open it up .See screen as below:
3. click “Firmware” and then open file option to select “X800_1_1”for Step 2. Click
“Upgrade” for start upgrade
Program is upgrading as below chart.
3. Upgrade interface appears “upgrade firmware successful﹗”and then click “Leave”
for Step 5, as following Chart.
4. Software upgrade is completed , you can unplug the USB upgrade cable
Pls refer to below image to connect your upgrade parts
cables
7.connect your upgrade cables and refer to our DEVO‐F12E manual to use your
drone.