1

Properties of Refractory Castables

Tina Stendal SvendsenProduct Manager

2

Refractory materials are subjected to following stress factors:• Thermal - by high temperatures and thermal shock• Mechanical - by pressure, impact, friction and airborne particles • Chemical - by gases, liquids, build-up, slag and melts

The properties of castables and their ability to withstand stresses are determined by:• Raw materials • Particle size distribution• Chemical reaction between raw materials at various temperatures

The properties of refractory castables can be analysed by a range of international test procedures

3

Bending strength; Modulus of rupture (EN 1402-6)

Cold modulus of ruptureProvides information on material structure (QC)

Hot modulus of ruptureCharacterize the thermodynamic behaviour of the castable

4

Cold Crushing Strength (EN 1402-6)

5

Thermal Shock Resistance (EN 993-11)

Air quenching of 950°C hot specimens

6

Abrasion resistance (ASTM C 704)

Temperature: 1000°CAbrasion media: SiC grainsTesting angle: 45° and 90°

Results:≤ 5cm3 loss: excellent5cm3 to 10cm3: very good10cm3 to 20cm3: good

7

Alkali resistance (CEN/TS 15418)

Test media K2CO3 or K2SO4

8

Hot-melt slag and build-up

9

Slag resistance: Static test (CEN/TS 15418)

10

Hot melt slag resistance (dynamic test)

11

Open porosity (EN 933-1)Test pieces are saturated in water under vacuum

12

The influence of porosity on castable properties

13

Other tests

• Particle size distribution

• Thermal expansion / creep

• Chemical and structural analyses; SEM and XRD

• Thermal conductivity

• Refractoriness / refractoriness under load

• CO-resistance

14

Assessment of material data

15

Temperature

Thermal property

Application

16

17

18

19

Summary• Castables are subjected to thermal, mechanical and chemical

stresses• Wide range of international test standards to measure properties• Some tests are targeted for quality control • Other tests simulate operation conditions (temperature, chemicals)• Test of corrosive slags can both static and dynamic• Test slags at relevant temperatures• There is a close relationship between porosity and the physical and

chemical properties of castables• When comparing datasheets: Be aware of test-temperature and of to

which temperature has the test specimens been prefired prior to test