HOW TO CHANGE IP INTERFACE IN EMAS > GO TO TOOLS CLICK O&M ACCESS CONFIGURATION NOTE: 1ST REMOVE THE TX CABLE

> CLICK NEXT

> CLICK NEXT

> CLICK NEXT

> FILL UP THE NEW IP & SUBNET MASK > THEN CLICK NEXT

> CLICK NEXT

> ADDING OF STATIC ROUTING > NEXT HOP IP ADD PUT THE O&M GATEWAY > FOR ROUTE METRIC JUST PUT VALUE OF 10 > THEN ADD

> CLICK NEXT

> CLICK NEXT

> CLICK NEXT

> CLICK NEXT

> CLICK FINISH

> CONFIRM CONFIGURATION

> WAIT TO RECONNECT INTO THE NEW IP

> THEN CLICK OK

> GO TO NEXT SHEET (DELETE SYNCHRONIZATION)

CREATED BY: MVLOPEZ

HOW TO CHANGE IP INTERFACE IN EMAS > GO TO TOOLS CLICK O&M ACCESS CONFIGURATION NOTE: 1ST REMOVE THE TX CABLE

> ADDING OF STATIC ROUTING > NEXT HOP IP ADD PUT THE O&M GATEWAY > FOR ROUTE METRIC JUST PUT VALUE OF 10 > THEN ADD

HOW TO CHANGE IP INTERFACE IN EMAS > GO TO TOOLS CLICK O&M ACCESS CONFIGURATION NOTE: 1ST REMOVE THE TX CABLE

> HOW TO DELETE SYNCHRONIZATION VIA EMAS > CHOOSE IP

> EXPAND THE IPOAM=1 FROM MO TREE > CLICK SYNCHRONIZATION=1

> GO TO MO PROPERTIES > CLICK ATTRIBUTES (13)

> EXPAND THE MO PROPERTIES (+) > COPY THE MANAGE ELEMENT

> JUST GO TO ACTION (4) > DROP DOWN THE WINDOW AND CLICK REMOVE SYNCREF RESOURCE

> PASTE THE MANAGE ELEMENT IN SYNC REFERENCE > THEN CLICK EXECUTE

> SAME PROCEDURE ABOVE SYNCREF = 7 >THEN CLICK EXECUTE…

> AFTER EXECUTE MAKE CV "AFTER_DELETE_SYNCREF" AND JUST PLACE AGAIN THE TRANSMISSION CABLE AND RESTART THE CABINET.

> AFTER RESTART WAIT TO INITIALIZED THE RBS CABINET.

> CALL RNC TO START THE NEXT PROCEDURES.

CREATED BY: MVLOPEZ

> EXPAND THE IPOAM=1 FROM MO TREE > CLICK SYNCHRONIZATION=1

> EXPAND THE MO PROPERTIES (+) > COPY THE MANAGE ELEMENT

> JUST GO TO ACTION (4) > DROP DOWN THE WINDOW AND CLICK REMOVE SYNCREF RESOURCE

> PASTE THE MANAGE ELEMENT IN SYNC REFERENCE > THEN CLICK EXECUTE

> SAME PROCEDURE ABOVE SYNCREF = 7 >THEN CLICK EXECUTE…

> AFTER EXECUTE MAKE CV "AFTER_DELETE_SYNCREF" AND JUST PLACE AGAIN THE TRANSMISSION CABLE AND RESTART THE CABINET.