PRINTER CONFIGURATION

GUIDE

Scangle SGT-C2008 thermal printer

A. Scangle SGT-C2008 thermal printer USB Port installation

C. To print test page.

B. Scangle SGT-C2008 thermal printer USB Port configuration

D. Configure the printer in the POS system

Step 1. Double click SGT-C2008 Driver.exe

Step 2. Click Next

A. Scangle SGT-C2008 thermal printer USB Port installation

Step 3. Click I accept the agreement

Step 4. Click Install.

Step 5. Click the Large button.

Step 6. Click continue

Step 7. Select Windows XP.

Step 8. Click Next.

Step 9. Click OK.

Step 12. Click Finish.

B. Scangle SGT-C2008 thermal printerUSB Port configuration

Step 1. Click Start.

Step 2. Click Printers and Faxes.

Step 3. Right click POS80 printer

Step 3. Click properties.

Step 4. Click Ports.

Step 5. Pull down the ports.

Step 6. Click check the USB001.

Step 7. Click Apply.

Note : To check if the printer is properly printing click this button Print Test Page.

Step 8. Click OK.

C. To print test page.

Step 9. Click Print Test Page.

Note : To check if the printer is properly printing click this button Print Test Page.

D. Configure the printer in the POS system

Step 1. At the cashier window. Click System setup.

Step 2. Input the admin/supervisor user name and password.

Step 3. Click OK.

Step 4. Click Printing.

Step 5. At the System Printer select Epson.

Step 6. At the System Printer Name select POS80.

Step 7. Click Save. Then Click OK. You can now use the printer.

THANK YOU!

www.tanaytechnologies.comDate created : 03-08-2012