PrincessSeamPatternGenerator1.0

3
Anny's Princess Seamed Bodice Generator Version 1.0 Measurements Needed: Final Measurements Chest above breast top 1 Bust bust 1 Under bust under bust 1 Waist 0 waist 1 Under arm to waist 0 Under arm to bust 0 Di Waist to Under bust 0 For Pattern Piece #1 (Front) Cut 1 Length 2 Top line 1.5 Bust Line 1.5 Under bust Line 1.5 Waist Line 1.5 Waist to Under bust 0 Under bust to Bust 0 For Pattern Piece #2 (Side Front) Cut 2 Length 2 Top line 1.5 Bust line 1.5 Under bust Line 1.5 Waist Line 1.5 Waist to Under bust 0 Under bust to Bust 0 For Pattern Piece #3 (Back) Cut 2 Length 0.5 Top Line -0.75 Bust Line -0.75 Under bust Line -0.75 Waist Line -0.75 Notes All measurements in inches 1/2'' Seam allowances included in final numbers Directions are for each section and are to use measurements for that s Only goes down as far as waist. Length lengthened by 1.5'' to make up for waistband seam allowances an Make a line the length of Top the middle of that line, draw bottom of that line, make a l intersect the middle of Waist Under bust and draw a line th intersect Length. Measure up to Bust Line. Draw a line the Draw a line the length of Len will be the seam at your side Top Line. Measure down an inc mark on Length. Erase the cor Line. On the other end of Wai perpendicular line extending length of Under bust to Bust. Draw a rectangle that is Leng bottom in the middle, make a correct.

description

princess seam pattern DIY

Transcript of PrincessSeamPatternGenerator1.0

Page 1: PrincessSeamPatternGenerator1.0

Anny's Princess Seamed Bodice GeneratorVersion 1.0

Measurements Needed: Final Measurements CalculatedChest above breast top 1Bust bust 1Under bust under bust 1Waist 0 waist 1Under arm to waist 0Under arm to bust 0 DirectionsWaist to Under bust 0

For Pattern Piece #1 (Front) Cut 1Length 2Top line 1.5Bust Line 1.5Under bust Line 1.5Waist Line 1.5Waist to Under bust 0Under bust to Bust 0

For Pattern Piece #2 (Side Front) Cut 2Length 2Top line 1.5Bust line 1.5Under bust Line 1.5Waist Line 1.5Waist to Under bust 0Under bust to Bust 0

For Pattern Piece #3 (Back) Cut 2Length 0.5Top Line -0.75Bust Line -0.75Under bust Line -0.75Waist Line -0.75

NotesAll measurements in inches1/2'' Seam allowances included in final numbersDirections are for each section and are to use measurements for that section.Only goes down as far as waist.Length lengthened by 1.5'' to make up for waistband seam allowances and for more modesty at the top.

These should NOT be the same as the measurements you took, but instead 1'' bigger. This isn't a second layer of skin, you know. You can always tailor it to fit better if you need to.

Make a line the length of Top Line horizontally across the paper. Starting in the middle of that line, draw a vertical line the length of Length. At the bottom of that line, make a line the length of Waist Line. Length should intersect the middle of Waist. Measure up from Waist the length of Waist to Under bust and draw a line the length of Under bust Line. The middle should intersect Length. Measure up from Under bust Line the distance of Under bust to Bust Line. Draw a line the length of Bust Line, with the middle intersecting Length. Connect the ends of the lines, making sure to curve them slightly from Top to Bust to Under bust.

Draw a line the length of Length. All lines will extend from this and will not intersect it. Length will be the seam at your side. At the top of the Length line, draw a perpendicular line the length of Top Line. Measure down an inch and a half on Length line and mark. Draw from the far end of Top to the mark on Length. Erase the corner. At the bottom of the Length line, draw a line the length of Waist Line. On the other end of Waist line, draw a line equal to Waist to Under bust. From this line, draw a perpendicular line extending from Length the length of Under bust Line. Measure up from this line the length of Under bust to Bust. Make a line extending from length the length of Bust Line. Connect the ends, making sure to curve them from Top to Bust to Under bust.

Draw a rectangle that is Length x Bust Line in dimensions. On the bottom in the middle, make a dart to make the waist measurement correct.

Page 2: PrincessSeamPatternGenerator1.0

Anny's Princess Seamed Bodice GeneratorVersion 1.0

Directions

Midpoints

Top Line 0.75Bust Line 0.75Under bust 0.75Waist 0.75

Dart Placement-0.38 < Middle of Dart0.00 <Measure out from each side of middle of dart this far

These should NOT be the same as the measurements you took, but instead 1'' bigger. This isn't a second layer of skin, you know. You can always tailor it to fit better if you need to.

Make a line the length of Top Line horizontally across the paper. Starting in the middle of that line, draw a vertical line the length of Length. At the bottom of that line, make a line the length of Waist Line. Length should intersect the middle of Waist. Measure up from Waist the length of Waist to Under bust and draw a line the length of Under bust Line. The middle should intersect Length. Measure up from Under bust Line the distance of Under bust to Bust Line. Draw a line the length of Bust Line, with the middle intersecting Length. Connect the ends of the lines, making sure to curve them slightly from Top to Bust to Under bust.

Draw a line the length of Length. All lines will extend from this and will not intersect it. Length will be the seam at your side. At the top of the Length line, draw a perpendicular line the length of Top Line. Measure down an inch and a half on Length line and mark. Draw from the far end of Top to the mark on Length. Erase the corner. At the bottom of the Length line, draw a line the length of Waist Line. On the other end of Waist line, draw a line equal to Waist to Under bust. From this line, draw a perpendicular line extending from Length the length of Under bust Line. Measure up from this line the length of Under bust to Bust. Make a line extending from length the length of Bust Line. Connect the ends, making sure to curve them from Top to Bust

Draw a rectangle that is Length x Bust Line in dimensions. On the bottom in the middle, make a dart to make the waist measurement correct.