Powerplant Juniorpower supply

user manual

Musikhaus Thomann e.K.

Treppendorf 30

96138 Burgebrach

Germany

Telephone: +49 (0) 9546 9223-0

email: info@thomann.de

Internet: www.thomann.de

02.02.2012

Table of contents

1 General notes............................................................................................................................................... 4

2 Safety instructions..................................................................................................................................... 6

3 Installation and starting up................................................................................................................ 10

4 Components and functions................................................................................................................ 15

5 Technical specifications....................................................................................................................... 17

6 Protecting the environment.............................................................................................................. 18

Table of contents

Powerplant Junior

3

1 General notes

This user manual contains important information on the safe operation of the device. Read andfollow all safety notes and all instructions. Save this manual for future reference. Make surethat it is available to all persons using this device. If you sell the device to another user, be surethat they also receive this manual.

Our products are subject to a process of continuous development. We therefore reserve theright to make changes without notice.

This section gives an overview of the symbols and signal words used in this user manual.Symbols and signal words

General notes

power supply

4

Signal word Meaning

DANGER! This combination of symbol and signal wordindicates an immediate dangerous situationthat will result in death or serious injury if it isnot avoided.

NOTICE! This combination of symbol and signal wordindicates a possible dangerous situation thatcan result in material and environmentaldamage if it is not avoided.

Warning signs Type of danger

Warning – high-voltage.

Warning – danger zone.

General notes

Powerplant Junior

5

2 Safety instructions

This device transforms mains voltage into safety extra-low voltage, e.g. for the voltage supplyof effects pedals. Use the device only as described in this user manual. Any other use or useunder other operating conditions is considered to be improper and may result in personalinjury or property damage. No liability will be assumed for damages resulting from improperuse.

This device may be used only by persons with sufficient physical, sensorial, and intellectualabilities and having corresponding knowledge and experience. Other persons may use thisdevice only if they are supervised or instructed by a person who is responsible for their safety.

Intended use

Safety instructions

power supply

6

DANGER!Danger for childrenEnsure that plastic bags, packaging, etc. are disposed of properly and are notwithin reach of babies and young children. Choking hazard!

Ensure that children do not detach any small parts (e.g. knobs or the like) fromthe unit. They could swallow the pieces and choke!

Never let children unattended use electrical devices.

DANGER!Electric shock caused by high voltages insideWithin the device there are areas where high voltages may be present. Neverremove any covers.

There are no user-serviceable parts inside.

Safety

Safety instructions

Powerplant Junior

7

DANGER!Electric shock caused by short-circuitAlways use proper ready-made insulated mains cabling (power cord) with a pro‐tective contact plug. Do not modify the mains cable or the plug. Failure to do socould result in electric shock/death or fire. If in doubt, seek advice from a regis‐tered electrician.

NOTICE!Operating conditionsThis device has been designed for indoor use only. To prevent damage, neverexpose the device to any liquid or moisture. Avoid direct sunlight, heavy dirt, andstrong vibrations.

Safety instructions

power supply

8

NOTICE!Power supplyBefore connecting the device, ensure that the input voltage (AC outlet) matchesthe voltage rating of the device and that the AC outlet is protected by a residualcurrent circuit breaker. Failure to do so could result in damage to the device andpossibly injure the user.

Unplug the device before electrical storms occur and when it is unused for longperiods of time to reduce the risk of electric shock or fire.

Safety instructions

Powerplant Junior

9

3 Installation and starting up

Unpack and check carefully there is no transportation damage before using the unit. Keep theequipment packaging. To fully protect the device against vibration, dust and moisture duringtransportation or storage use the original packaging or your own packaging material suitablefor transport or storage, respectively.

Make all connections when the device is not connected to the mains voltage. Use the suppliedcables for all connections.

The following cable types are available:

n 5 standard cables (1:1), length 30 cm, each to supply one effects pedaln 5 standard cables (1:1), length 60 cm, each to supply one effects pedaln 1 Y-cable to supply one effects pedal that has a higher power consumptionn 1 serial cable to supply a maximum of 5 effects units from one 9 V outlet socket of the

power supply unit

Wiring

Installation and starting up

power supply

10

Connect – as shown in the drawing – the plug of one of the standard cables to the 9 V powersupply input of an effects pedal. Connect the other plug to a 9 V output socket of the powersupply unit. In order to avoid an overload of the power supply, the current draw of each con‐nected pedal must not exceed 120 mA.

1:1-Wiring

Installation and starting up

Powerplant Junior

11

Connect – as shown in the drawing – the single plug to the 9 V power supply input of aneffects pedal. Connect the plug pair of the Y-cable to two 9 V output sockets of the powersupply. In order to avoid an overload of the power supply the current draw of the connectedpedal must not exceed 240 mA.

Y-cable

Installation and starting up

power supply

12

The serial cable is used to power several effects pedals standing next to each other in a clearway. Connect – as shown in the drawing – the five output jacks of the serial cable to the DCinputs of the effects units. Connect the input jack of the cable to one of the 9 V outlets of thepower supply. The total current draw of all connected pedals must not exceed 120 mA, thusleaving a maximum of 24 mA to each pedal when using devices of the same kind..

Serial cable

Installation and starting up

Powerplant Junior

13

Installation and starting up

power supply

14

4 Components and functions

Components and functions

Powerplant Junior

15

1…5 DC 9 V outlet sockets

6 Red pilot light. Indicates that the device is powered by mains voltage.

Components and functions

power supply

16

5 Technical specifications

Supply voltage AC 230 V , 50 Hz

Current draw 30 mA

Output voltage 5 × DC 9 V

Output current 5 × 120 mA

Dimensions (W × D × H) 116 mm × 77 mm × 38 mm

Weight 920 g

Technical specifications

Powerplant Junior

17

6 Protecting the environment

For the transport and protective packaging, environmentally friendly materials have beenchosen that can be supplied to normal recycling.

Ensure that plastic bags, packaging, etc. are properly disposed of.

Do not just dispose these materials with your normal household waste, but make sure thatthey are fed to a recovery. Please follow the notes and markings on the packaging.

This device is subject to the European directive 2002/96/EC.

Do not dispose the device with your normal household waste.

Dispose this device through an approved waste disposal firm or through your local wastefacility. When discarding the device, comply with the rules and regulations that apply in yourcountry. If in doubt, consult your local waste disposal facility.

Disposal of the packaging mate‐rial

Disposal of your old device

Protecting the environment

power supply

18

Musikhaus Thomann e.K. · Treppendorf 30 · 96138 Burgebrach · Germany · www.thomann.de