Polishing your car with hand here's how you do it

4

Click here to load reader

Transcript of Polishing your car with hand here's how you do it

Page 1: Polishing your car with hand here's how you do it

Polishing Your Car

With Hand - Here's

How You Do It!

Page 2: Polishing your car with hand here's how you do it

Car should be properly polished before the car polished by hand, some preparations

must be made. If possible, polished to the car at an overcast sky or one previously looks

for a place in the shade. Apart from the fact that the polishing of a car in direct sunlight

extremely sweaty affair is: almost all skin care products achieve the desired effect not

when direct sunlight is.

Fix condition of the car

How to do next, depends entirely on the condition of the paintwork. If this still shines

nicely and there are no differences in color, for example, milky-looking faces on the

bonnet or roof, can be polished.

Dull or "piebald" paint must be treated before or with paint cleaner.

It is about a preparation which contains tiny abrasive particles and thus the top layer of

paint is removed. Would you get a good end result, this strenuous operation can not be

omitted.

Just a small amount of the cleaner on a fist-sized bales car polishing wadding enter and

edit small patches of paint on intensive way circular.

The swab is taken up in a short time on the hue of the paint, which is a sign that you

have reached the desired result. Once the paint is dry cleaner, take the remaining

remnants from a further cotton bales from the paint.

Page 3: Polishing your car with hand here's how you do it

The cotton should always be turned over and replaced more frequently!

Watching but you should at ridge-like

body panels and edges. On such parts

one exerts pressure on a very small part

surface, thereby drastically increases.

Assuming careless before, the top coat

may be up to the primer by ground

quickly.

So the car is hand polished

(manual):

the polishing agent is plotted never

directly on the paint, but only on the

polishing plate of Poliermaschiene (if

any), Auftragepad, soft cloths or polishing

wadding. Observe, liquid polish is spread more easily than Politurpaste.

Start should the roof and working systematically down. Here you wear the polish on

easily and evenly (with small circular movements) and distributes them. It is advisable to

always edit only a partial surface and not equal to the entire car, because the polish

dries otherwise too long, is hard and the subsequent polishing can therefore be quite

strenuous.

Page 4: Polishing your car with hand here's how you do it

If a body part, for example bonnet or roof polished allowed to eintrochnen polishing

something until a fine white veil is formed. Then wipe with a new clean bales polishing

cotton or cloth, the remains of the polish with light circular movements from. Do not

forget the cotton bales / cloth often turn the buff up! It is also important in this case, with

constant gentle pressure to work.

If the cotton wool or the polishing cloth is saturated with the polishing, it has to be

discarded is not the same. One may use the rebate of a door or for the engine

compartment it still.

Similarly, one can replace the job bales without problems by a Nachpolierballen and use

for polishing simple new cotton. You should remember, possibly to treat existing chrome

parts on the car. These should be protected finally shine again and.

Can be found after polishing even smaller dull areas, it may be in this order superficial

abrasions tracks. These can be removed with high probability with an abrasive polishing

paste, which you get in the car accessories.

Add a little of it to a polishing cotton wool and rub the point a until the scratches are no

longer visible. Then the subarea should be polished with a car polish after.

For more tips please visit our site here: http://www.pressureforever.com/best-car-polisher-review/