Congratulations on the purchase of your Modeno desk. This Desk has been crafted to the highest standards of quality and safety and will give you many years of enjoyment and practical use.

This desk is a natural wood product and has been �nished with a distressed patina. There will be variations in color and grain, and minor wood grain checking may occur. This is normal and does not compromise the integrity of your desk. Variation in the character of this piece is integral to its beauty and distinguishes it from lower quality composite materials.

Assembly is quite simple and requires only a Phillips head screwdriver. Assembly will be most easily accomplished if you take the time to carefully sort the hardware and familiarize yourself with the function of each piece.

If you should require assistance with assembly, part replacement or any other matter, contact the toll-free Epoch Design Service Center from anywhere in the Continental United States, Monday through Friday, 9 AM – 5 PM Paci�c Standard Time at 1-800-589-7990. You may also email your request or comments to info@epochbydesign.com and a service representative will respond. Thank you and Enjoy

EPOCH DESIGN , LLC Modeno Desk5304: PM-OS-DE-ES

1x Allen Wrench 8x Lock Washers 8x Washers 8x 70mm Allen bolts

HARDWARE LIST

PARTS LIST

mm 10 20 30 40 50 60 70

2x Wooden handle with screw

2x Metal handle with screw

1x Desktop 4x Desk legs

2x Storage Boxes

28-Feb-20191/2

HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990Copyright © 2019 Epoch Design™ All rights reserved

II

28-Feb-20191/2

HAVE QUESTIONS OR CONCERNS? CALL US FIRST: 1-800-589-7990Copyright © 2019 Epoch Design™ All rights reserved

Lock Washer

Washer

70 mm bolt

Carefully position the desktop, top side down on a clean and soft surface.

Attach each leg to the desktop using a lock washer, a washer, and a 70mm bolt in all 8 pre-drilled holes in the bottom of the desktop. As shown in Diagram I.

Tighten with the allen wrench.

1

2 Carefully turn the desk right side up.

To install the drawer handle, �rst unscrew the handle from the inside of the drawer. (As shown in Diagram II)

Place the handle on the outside of drawer and insert the screw through the pre-drilled hole located on the inside of the drawer. Tighten using a Phillips head screwdriver. (As shown in Diagram III).

I

III NOTE: Do not turn the handle to tighten or loosen the screw. Doing so will cause the handle to scratch the front of the door.