Photogrammetry
-
Upload
space-generation-advisory-council -
Category
Education
-
view
620 -
download
9
description
Transcript of Photogrammetry
![Page 1: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/1.jpg)
PhotogrammetryPhotogrammetryProf. W.N. Wilson Department of Geography
![Page 2: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/2.jpg)
DefinitionsDefinitions
The science or art of obtaining reliable measurements by means of photography (American Society of Photogrammetry, 1956)
The art, science and technology of obtaining reliable information about physical objects and the environment by recording, measuring and interpreting photographic images (American Society for Photogrammetry and Remote Sensing, 1987)
The use of photography for accurate measurement is called photogrammetry (simple definition)
![Page 3: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/3.jpg)
Aerial photographs are Aerial photographs are notnot mapsmaps
Aerial Photographs are single-point perspective views of the Earth’s surface, whereas maps are orthogonal representations of the surface
Sizes shapes and positions of objects are distorted in aerial photographs
However, aerial photographs can be used to construct maps and to accurately measure distances, heights and elevations.
![Page 4: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/4.jpg)
Orthogonal representations of Orthogonal representations of the surface (MAP)the surface (MAP)
Figure - 1
![Page 5: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/5.jpg)
Single-point perspective views of Single-point perspective views of the Earth’s surface the Earth’s surface (AERIAL (AERIAL PHOTOGRAPH)PHOTOGRAPH)
Figure - 2
![Page 6: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/6.jpg)
If the terrain is completely flat and horizontal, the vertical photograph is same as map. If difference in height occur, then relief displacement becomes appearance. Pole AB appears as a point on map and as line on aerial photo. So aerial photo cannot be used as a map.
![Page 7: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/7.jpg)
Figure - 3
![Page 8: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/8.jpg)
Then how to prepare maps from Then how to prepare maps from aerial photographs?aerial photographs?
To overcome relief displacement, which is shown above, two photographs are taken of the same area at different positions. These photographs are overlapped and viewed stereo viewing devices and using this principle a map can be prepared.
Figure – 4
![Page 9: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/9.jpg)
There are two kinds of photographs used in photogrammetry, aerial and terrestrial.
◦Aerial photographs are usually acquired from aircraft but can also come from satellites, hot air balloons or even kites.
◦Terrestrial photographs come from cameras based on the ground (Photo Theodolites), and generally are used in different applications from aerial
![Page 10: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/10.jpg)
There are two main data extraction methods used for analyzing these photographs:
◦Quantitative: that is size, length,
shape, height, area etc.◦Qualitative : geology, vegetation,
drainage, land use etc. This section is primarily concerned with
the quantitative evaluation of survey photographs.
![Page 11: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/11.jpg)
The Aerial CameraThe Aerial Camera
![Page 12: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/12.jpg)
The rays of light pass through one central point in the lens of a survey camera, and the distance between this point and the film is calibrated to decimals of a millimeter. This distance is known as the focal length.
The film plane is as flat as possible, often using flattening devices to achieve this.
The camera body also carries reference marks known as fiducial marks that define a coordinate measurement axis and allow film stretch to be determined.
The camera is also very large, the size of the negatives is 23cm by 23cm which is somewhat bigger than the average snapshot.
The cameras are constructed in this manner so that measurements of a high accuracy and precision can be obtained.
![Page 13: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/13.jpg)
Air-photo terminology
Fiducial marks: Marks on the photograph margins used to locate principal point in photo.
Nadir point:-The vertical line passing through the perspective centre (camera lens) intersects the negative plane of at nadir point (n).
Principal point: The orthogonal projection of the perspective centre on the negative (photo) is the principal point. In other words it is the geometric centre of photograph.
Principal distance:- The distance from projection centre to negative plane (c).
Iso centre: The angle is called the angle of the maximum tilt. The point where the line bisecting this angle intersects the negative plane is the isocentre (i).
Principal axis:- The perpendicular line from the perspective centre on the negative plane.
![Page 14: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/14.jpg)
Principal line:- The line joining the nadir point and principal point.
Principal plane:- The plane containing perspective centre , nadir point, iso centre, principal point, principal axis and principal line.
Iso line:- A line representing the intersection of the plane of a vertical photograph with the plane of an over lapping oblique photograph.
Axis of tilt :- A line through the perspective centre perpendicular to principal plane.
Conjugate principal point: Point in overlapping photo that is equivalent to principal point of adjacent photograph.
Photo base: Distance between principal point and conjugate principal point measured on a single photograph.
Ground (air) base: Ground (air) distance between principal points of overlapping photographs.
Parallax: Apparent shift in relative positions of objects when viewed (photographed) from different vantage points.
![Page 15: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/15.jpg)
Exercises: 1. On photo, the distance between nadir
point and principal point is 0.5cm. Focal length is 200mm. Determine the tilt.
Tan a = 5/200 a = 1 25’ 55.6”
2. The distance between principal point & nadir point 20mm. C=210mm. Where is the iso center?
![Page 16: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/16.jpg)
Comparison of aerial photographs
vertical, oblique and high oblique
Photographs
High oblique
Low oblique Vertical
Characteristic
Horizon on photo
No horizon photo
Tilt smaller than 4 degrees
Coverage Greater (wide)
Less (normal) Least (narrow)
Area (shape) Trapezoidal Trapezoidal Rectangular
Scale Decrease from for ground to back ground
Like as high oblique but lesser extent
Uniform for one level
Comparison with map
Greatest difference
Less Least
Advantage Economic Easiest to map
![Page 17: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/17.jpg)
The Geometry of the Aerial Photograph
The average scale of the aerial photograph can be computed either by taking the ratio of the flying height above the ground and the focal length (f/H), or by taking the ratio of a known distance in the photograph and the distance on the ground.
As the flying height above the ground is not usually known accurately, the second method is employed where a more reliable scale is needed.
![Page 18: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/18.jpg)
Exercises: 1. Focal length = 6” Flying height = 12000ft Scale = 6”/ 12000’ = 1:20000
2. c = 210mm and Z = 4200 m Scale = 210mm / 4200m = 1:2000
3. The measured distance between points A & B is 215mm. The given co-ordinates are XA =205346.39 m, YA = 10793.16m ; XB =205100.11m, YB = 11587.98 m. Find the scale
![Page 19: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/19.jpg)
Neither of the two scale calculation methods give an accurate scale as there are two distortions that affect measurements made on a single aerial photograph.
![Page 20: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/20.jpg)
a. Height distortion:Because a lens and a photograph give a perspective or central projection, objects that are above or below the plane will be shifted by an amount approximately
b. Tilt distortion:Although a lot of care is taken in the flying of aerial photography the photographs are rarely taken exactly horizontal. The tilts that occur in the aircraft, although kept to a minimum by the levelling of the camera system, do affect the position of objects on the photograph.
There are other distortions such as film shrinkage, earth curvature, refraction effects and so on but these are only significant when dealing with precise photogrammetry.
![Page 21: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/21.jpg)
Determining the height of an object from shadow length
h = L tanwhere H = flying height
h = height of the vertical object
L = length of the shadow
= sun elevation angle
f = focal length
Conditions:- The shadow on which the ground falls is level. The object is vertical
![Page 22: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/22.jpg)
Sun elevation angle:Sun elevation angle:The sun angle above local
horizon can be derived using a solar ephemeris table, given the latitude and logitude of the site and photograph acquisition date and time.
![Page 23: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/23.jpg)
Relief displacementRelief displacement
Any objects that are higher or lower than the principal point are displaced from its true planimetric (x,y) location on a vertical aerial photograph. This displacement is referred to as relief displacement or terrain distortion.
The relief displacement is outward from the principal point for objects whose elevations are above the local datum, and toward the principal point for objects whose elevation are below the local datum.
The direction of relief displacement is radial from the principal point.
![Page 24: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/24.jpg)
Height from Relief Height from Relief DisplacementDisplacement
Figure
![Page 25: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/25.jpg)
Simple definitionSimple definition::
Relief displacement is the distance between the position of a point on the photograph if it was on the reference plane and its actual position due to relief.
![Page 26: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/26.jpg)
Conditions for Relief Conditions for Relief Displacement Method to find Displacement Method to find object heightobject height
Aerial photographs must be vertical or near vertical (<3° of tilt). Namely, the principle point is the photo nadir.
The top and the bottom of the object are visible
The object is on level base and vertical.
![Page 27: Photogrammetry](https://reader034.fdocuments.in/reader034/viewer/2022051413/5583839ad8b42ac6268b5581/html5/thumbnails/27.jpg)
Exercises:
1. On flat horizontal terrain there is erected a flag pole of 25 m. The distance from the nadir point of the vertical photograph to the pole is 300 m. The flying height is 1000 m. Principal distance is 200 mm. Compute the relief displacement
2. On a photo of flat terrain there is an isolated hill 200m high. Flying height is 2000m. What is the greatest value of relief displacement which we may find ?