PhoneWatch Home Safety System - Quick Guide Home Safety System - Quick Guide KEYPAD TONES Each time...
Transcript of PhoneWatch Home Safety System - Quick Guide Home Safety System - Quick Guide KEYPAD TONES Each time...
PhoneWatch Home Safety System - Quick Guide
Arming Press + 4 Figure code or KEYTAG, This arms the entire system (Away)
Press + 4 Figure code or KEYTAG, Arms part of the system (Home)
* KEYTAG - place the keytag over the number 8
Disarming Enter a valid user code or use keytag (place keytag over the number 8).The keypad then gives a disarmed tone and green light goes out
Indicator Lights
The keypad has indicator lights to show the current status of the alarm system
Light 1 “SYSTEM ARMED”
ALIGHT: The entire system is armed (away)BLINKING SLOWLY: Part of the system is armed (Home)OFF: System is disarmed
Light 2 “SYSTEM FAULT”
ALIGHT: There is a fault in the system (batteries, power, gsm).If this light stays on contact PhoneWatchBLINKING SLOWLY: Fault is registered in system memory needs to be resetOFF: No Fault
Light 3 “ALARM ACTIVATED”
ALIGHT: The alarm has been activated.This includes opening a door contact and being in sight of a motion sensorBLINKING SLOWLY: There is an alarm activation registered in the MemoryOFF: No alarm activation
Light 4 “SENSOR/PANEL TAMPER WARNING”
ALIGHT: There is an issue with a sensor/panelBLINKING SLOWLY: There is a fault registered in the system Memory,needs to be reset OFF: No sensor warning
PhoneWatch Home Safety System - Quick Guide
PhoneWatch Home Safety System - Quick Guide
KEYPAD TONES
Each time you set your alarm panel you will hear a series beepsprior to the arming tone.
Arming - On arming one beep per second Arming on the away function: the beeps continue until the outer door is closedArming on the home function: the beeps continue for 30 seconds until the system is armed
Disarming - Long, continuous beep The duration of this beep is about 2.5 seconds. This confirms that the system has been properly disarmed
Entry delay - On entry one beep per secondThis entry delay continues for 20 seconds* after you have opened the outer door. You must disarm the system within this time. Please note The entry beeps wont start beeping immediately when entering but the delay you have to get to the panel to disarm it will start straight away
Fault - 7 rapid beeps followed by 7 moreThis indicates a fault in the system
Alert - 4 beeps in the event of alarm activation sent via keypadConfirms the transmission of an alarm activation to PhoneWatch
Call us on 1850 753 753 or chat online at phonewatch.ie/customer-support
To view full user manual visit phonewatch.ie/uploads/manual.pdf
Please ensure you close all interior and exterior doors
and windows before setting your alarm