Pertemuan 25 Configuring Frame Relay
description
Transcript of Pertemuan 25 Configuring Frame Relay
1
Pertemuan 25 Configuring Frame Relay
Discussion Topics
• Configuring basic Frame Relay• Configuring a static Frame Relay map• Reachability issues with routing updates in NBMA• Frame Relay subinterfaces• Configuring Frame Relay subinterfaces• Verifying the Frame Relay configuration• Troubleshooting the Frame Relay configuration
2
Configuring Basic Frame Relay
Configuring a Static Frame Relay Map
Reachability Issues with Routing Updates in NBMA
Reachability Issues with Routing Updates in NBMA
By default, a Frame Relay network provides nonbroadcast multiaccess (NBMA) connectivity between remote sites. An NBMA environment is treated like other multiaccess media environments, where all the routers are on the same subnet.
Frame Relay Subinterfaces
Configuring Point-to-Point Subinterfaces
Verifying Frame Relay
• The show interfaces command displays information regarding the encapsulation and Layer 1 and Layer 2 status. It also displays information about the following:– The LMI type – The LMI DLCI – The Frame Relay data terminal
equipment/data circuit-terminating equipment (DTE/DCE) type
The show interface Command
LMI Type
LMI DLCI
LMI Status
The show frame-relay lmi Command
The show frame-relay pvc Command
The show frame-relay map Command
Troubleshooting Frame Relay The debug frame-relay lmi
Command
PVC Status0x2 – Active0x0 – Inactive0x4 – Deleted