Personal Protective Equipment (PPE)

17
1 Personal Protective Equipment (PPE) OTI 501 Trainer Course in Occupational Safety and Health Standards for General Industry

description

Personal Protective Equipment (PPE). OTI 501 Trainer Course in Occupational Safety and Health Standards for General Industry. Personal Protective Equipment (PPE). PPE should not be used as a substitute for: engineering controls work practices administrative controls. Why Wear PPE?. - PowerPoint PPT Presentation

Transcript of Personal Protective Equipment (PPE)

Page 1: Personal Protective Equipment  (PPE)

1

Personal Protective Equipment (PPE)

OTI 501

Trainer Course in Occupational Safety and

Health Standards for General Industry

Page 2: Personal Protective Equipment  (PPE)

2

Personal Protective Equipment (PPE)

PPE should not be used as a substitute for:engineering controls

work practices

administrative controls

Page 3: Personal Protective Equipment  (PPE)

3

Why Wear PPE?

Barrier against workplace hazardsprevent over exposure

To prevent take home contaminationprevent exposure to others outside of the

work environment

Page 4: Personal Protective Equipment  (PPE)

4

Standard Operating Procedures for PPE

Evaluation of equipment needed to protect workers

Employee training– selection– use– maintenance– limitations

Page 5: Personal Protective Equipment  (PPE)

5

Personal Protective Equipment (PPE)

OSHA incorporated the regulatory text of the General Industry Safety and Health Standards that have been identified as applicable to construction work into the Safety and Health Regulations for Construction (29 CFR Part 1926) on 6/30/93.

Page 6: Personal Protective Equipment  (PPE)

6

Personal Protective Equipment (PPE)

1926.95 is the "new" PPE standard in construction.

»Protective Equipment; Final Rule was issued on April 6, 1994.

Page 7: Personal Protective Equipment  (PPE)

7

29 CFR 1910.132

General Requirements» (b) Employee Owned Equipment

» (c) Design

» (d) Hazard Assessment

» (e) Defective and Damaged

» (f) Certification of Training

Page 8: Personal Protective Equipment  (PPE)

8

29 CFR 1910.132 Hazard Assessment

Impact

Penetration

Compression (roll-over)

Chemical

Heat

Harmful dust

Light radiation

Page 9: Personal Protective Equipment  (PPE)

9

29 CFR 1910.132

Appendix A - References

Appendix B - Non-Mandatory

»Compliance Guidelines for Hazard Assessment and Personal Protective Equipment Selection

Page 10: Personal Protective Equipment  (PPE)

10

29 CFR 1910.132

Training– when PPE is necessary– what PPE is necessary

• donning and doffing

– limitations– care, maintenance, useful life, and

disposal of PPE– certification of training

Page 11: Personal Protective Equipment  (PPE)

11

Personal Protective Equipment (PPE)

Criteria for Selection of PPE133 - Eye and face135 - Head136 - Foot137 - Electrical138 - Hand

Page 12: Personal Protective Equipment  (PPE)

12

29 CFR 1910.133

Eye and Face Protection

ANSI Z87.1-1968 ANSI Z87.1-1989 *

* Updated ANSI reference.

Page 13: Personal Protective Equipment  (PPE)

13

29 CFR 1910.135

Head Protection ANSI Z89.1-1969 ANSI Z89.1-1986 *

* Updated ANSI reference.

Page 14: Personal Protective Equipment  (PPE)

14

29 CFR 1910.136

Foot Protection ANSI Z41.1-1967 ANSI Z41-1991 *

* Updated ANSI reference.

Page 15: Personal Protective Equipment  (PPE)

15

ANSI

American National Standards Institute1430 Broadway

New York, NY 10018

(212) 642-4900

Page 16: Personal Protective Equipment  (PPE)

16

29 CFR 1910.138

Hand Protection»Relative to

»the task»conditions»duration»hazards

Page 17: Personal Protective Equipment  (PPE)

17

Personal Protective Equipment (PPE)

General Provisions

Selection Charts

Defective/Damaged

Certification of Training

Hazard Assessment