Performance and emission analysis on oxygen enriched variable Oxygen Enriched variable compression...

Performance and Emission Analysis on Oxygen Enriched variable

compression ratio Diesel Engine

SREESANKAR JM.E THERMAL ENGGSNS COLLEGE OF TECHNOLOGYCOIMBATORE-35

Abstract

• In this work, the investigation is carried out in variable compression ratio diesel engine with air side oxygen enrichment.

• This investigation aims to find out the optimum level of performance with various flow rates of oxygen and for various compression ratios.

• Initially the base line engine performance and emission characteristics are determined at different loads with different flow rates of oxygen.

Abstract

The experimental investigation shows that :• Increase brake thermal efficiency of the engine• brake specific fuel consumption and total fuel

consumption decreases• The emission result indicates that there is a

significant amount of reduction in CO emissions with the increase in flow rate of oxygen.

INTRODUCTION

• Diesel engines have considerable advantages in the market in the form of its power output, fuel economy and durability.

• environmental concerns and the emission regulations, said that to reduce emission of diesel engine simultaneously while keeping up a good fuel economy and power output.

• The IC engine is to produce mechanical power from chemical energy which is contained in the fuel.

• In recent years, growing concerns about environmental preservation have created a demand for a lower pollution automotive diesel engine.

LITERATURE REVIEW

• Watson, et al conducted experiments with oxygen-enriched air (up to 30% O2 by volume). They achieved about 80% reduction in smoke at full load and 5% to 12% increase of thermal efficiency and also a decrease of CO and HC emissions. However, NOx emission increased due to the increase of oxygen concentration and cycle temperatures.

• Poola, et al conducted experiments with oxygen enriched air in SI engine to reduce HC and CO emissions. It had a great advantage in the period where the catalytic converter temperature was below light off level. They achieved about 60% to 70% reduction in HC and CO emission levels with an increase of 23% of oxygen by volume.

EXPERIMENTAL SETUP

• An oxygen cylinder is connected to the inlet manifold of the diesel engine.

• oxygen flow meter is connected at the beginning of the connection from the oxygen cylinder.

• A mixing chamber is fixed to the inlet manifold of the engine for effective mixing of oxygen and air.

Engine configurations

Experimental Setup

Oxygen flow meter

Mixing Chamber

Experimental Setup

• Initially the experiment is conducted on a baseline engine which means without making any hardware modifications on the engine and the performance and emission characteristics are measured.

• The oxygen flow meter is used for setting up the various flow rates of oxygen in litres per minute.

• The flow rate of the oxygen is varied from 1 litre per minute to 7 litres per minute.

Experimental Setup

• For each flow rate of the oxygen the load is varied from no load to 8 kg and at each load condition, the performance and emission characteristics of the engine is examined and the results are compared with the performance and emission characteristics of the baseline engine which is not connected with the oxygen cylinder.

• The same procedure is applied to five different compression ratios which vary from 14:1 to 18:1 and the performance and emission characteristics are examined with oxygen being injected into the inlet manifold of the engine through a mixing chamber at various flow rates.

Measuring Methods

• brake thermal efficiency and fuel consumptions are calculated by measuring the fuel inlet flow rate to the engine which is measured using a burette along with scale.

• the exhaust emissions are measured with the help of exhaust gas analyzer (Kane-May 900 Combustion Analyzer and smoke meter.

RESULTS AND DISCUSSION

• The brake thermal efficiency of the engine was found to have a gradual increase with increase in oxygen flow rate.

Load vs brake thermal efficiency (C.R.14:1)


• The maximum brake thermal efficiency was experienced at flow rate of 7 liters/minute at the Compression ratio of 17:1


• The specific fuel consumption decreases with increase in the flow rate of oxygen.

Load vs Specific fuel consumption (C.R.14:1)


• The lowest specific fuel consumption was experienced at an oxygen flow rate of 7 liters/minute and at a compression ratio of 18:1.


• The emission analysis shows that with the increase in oxygen flow rate there was a significant reduction in CO emissions.

Load vs CO (C.R.14:1)

CONCLUSION

• The brake thermal efficiency is increased with increase in load and oxygen flow rate and the maximum of which was experienced at oxygen flow rate of 7 liters/minute and at the Compression ratio of 17:1.

• The specific fuel consumption was gradually reduced with increase in load and oxygen flow rate and it was lowest at the oxygen flow rate 7 litres per minute.

CONCLUSION

• The CO emissions were found to be reduced gradually with increase in oxygen flow rate and it was lowest at the oxygen flow rate of 7 liters per minute.

• The NOx emissions were found to be increasing gradually with increase in load and oxygen flow rate and which is due to increased combustion temperatures and oxygen concentration.

CONCLUSION

• The performance and emission characteristics of the engine were found to be optimum at the Compression ratio of 16:1.

• So, the engine can be operated efficiently by setting the compression ratio to 16:1.

REFERENCES1. G A Karim and G Ward., ”The Examination of the Combustion Process in a Compression

Ignition Engine by Changing the Partial Pressure of Oxygen in the Intake Charge,” SAE Paper No 680767.

2. H C Watson, et al., ”A New Look at Oxygen Enrichment in Diesel Engine,” SAE Paper No 900344.

3. R B Poola, et al., ”Utilizing Intake Air Oxygen-enrichment Technology to Reduce Cold-phase Emissions,” SAE Paper No 952420.

4. R J Donahue and D E Foster., ”Effect of Oxygen Enhancement on the Emission from DI Diesel via Manipulation of Fuel and Combustion Chamber Gas Composition,” SAE Paper No 2001-01-0512.

5. Theodoros C. Zannis and Dimitrios T.Hountalas., ”DI Diesel Engine Performance and Emissions form the Oxygen Enrichment of fuels with Various Aromatic Content,”.. ACS Paper No 659-666.

6. Sekar, R., Murr, W., Schaus, J., Cole, R. et al., "Cylinder Pressure Analysis of a Diesel Engine Using Oxygen-Enriched Air and Emulsified Fuels," SAE Technical Paper 901565, 1990, doi:10.4271/901565.

REFERENCES7. Marr, W., Sekar, R., Cole, R., Marciniak, T. et al., "Oxygen-Enriched Diesel Engine

Experiments with a Low-Grade Fuel," SAE Technical Paper 932805, 1993, doi:10.4271/932805.

8. Virk, K., Kokturk, U., and Bartels, C., "Effects of Oxygen-Enriched Air on Diesel Engine Exhaust Emissions and Engine Performance," SAE Technical Paper 931004, 1993, doi:10.4271/931004.

9. Desai, R., Gaynor, E., Watson, H., and Rigby, G., "Giving Standard Diesel Fuels Premium Performance Using Oxygen-Enriched Air in Diesel Engines," SAE Technical Paper 932806, 1993, doi:10.4271/932806.

10. Desai, R. and Watson, H., "Effects of Fuel Composition on D.I. Diesel Engine Particulates and Study of Oxygen-Enriched Diesel NO Formation," SAE Technical Paper 971143, 1997, doi:10.4271/971143.

Performance and emission analysis on oxygen enriched variable Oxygen Enriched variable compression...

Engineering

Transcript of Performance and emission analysis on oxygen enriched variable Oxygen Enriched variable compression...