Pemasangan Sistem Pemipaan Air Bersih
-
Upload
gus-andrian -
Category
Documents
-
view
210 -
download
4
Transcript of Pemasangan Sistem Pemipaan Air Bersih
ENGINEERING PLUMBING AND SANITATION
Application of Plumbing System Of Clean Water
System of Clean Water
Purpose Of Common Instructional :
1. After this Lesson solvent and understands in explaining system division of clean water .
Teknologi dan Rekayasa
Purpose Of Special Instructional Student can mention :
1. Direct joint system 2. Indirect joint system 3. Advantage and disadvantage of
one of system
Teknologi dan Rekayasa
Teknologi dan Rekayasa
Installation of Clean Water Pipe
To get safe installation there are some thing that need to be paid attention :
1. Material is not corrosion easy to
2. Pipe through wall must be given canopy
3. Applycation of pipe must be diametrical
Teknologi dan Rekayasa
4.Utilizes fitting for transformation of direction and transformation of diameter
5.Exactly in determination of pipe diameter
6.For vertical pipe labored straight to the above of from basis
7.Every floor gives one crane stops8.After meter water is attached [by]
crane which can prevent reverse flow
Teknologi dan Rekayasa
Example : Installation Scheme of Pipe in building
1. Principal pipe2. Housing joint3. Meter water4. Distributor pipe5. Supply pipe of clean water6. Vertical pipe7. Branch pipe for equipments sanitary
Correct installation :
Teknologi dan Rekayasa
In important installation again was all valves or crane attached at one particular installation didn't cause or can generate reverse flow and exploitation to return if there are
transformation of water pressure in installation.
1. Direct joint system
This system especially applied for low and small housing
And Example :
a. Shut off valve in plot of land
b. Shut off valve below(under road street)
physical plant.
Teknologi dan Rekayasa
Teknologi dan Rekayasa
a. Shut off valve in plot of land
Teknologi dan Rekayasa
b. Shut off valve below(under road street) physical plant.
2. Indirect joint system :
In this system, distribution pipe within doors indirectly is attributed to principal pipe of supply of cleanness water.
Water is accomodated in advance in the tank then is flown / pumped to be distributed in building for requirement of cleanness water would.
Teknologi dan Rekayasa
2.1. Roof tank system :
At this system, water is accomodated in advance in the tank under (attached to low floor of building or below(under ground face), then is pumped to an usual upper tank is attached above roof or above highest floor of building.
Teknologi dan Rekayasa
Teknologi dan Rekayasa
Drawing :System with roof tank
Compress tank system drawing
Teknologi dan Rekayasa
Application of Subterranean Pipe
Purpose Of Common Instructional :
1. After this Lesson solvent student and understands way of applications of pipe in ground.
Teknologi dan Rekayasa
Purpose Of Special Instructional Student can mention :
1. Dig aperture height 2. Way of putting down pipe in dig 3. Detention of pipe from at
dividing valve ( for big diameter ) 4. Pipe test
Teknologi dan Rekayasa
Applications of subterranean pipe
Teknologi dan Rekayasa
4 important factor of Applications subterranean pipe :
1.Dig aperture height
Teknologi dan Rekayasa
2. Situation of Pipe
Teknologi dan Rekayasa
Explanation
A. Situation of Correct pipe because :
Pipe exactly ground anvil.
Easy to checking of joint before landfill with ground
Teknologi dan Rekayasa
B. situation of Not accurate pipe because.
Ground anvil pipe only in each joint
Cannot guarantee lineation of pipe
If there are dividing valve from the top (of), very possibly pipe earns break
Teknologi dan Rekayasa
C. Situation of Pipe that is not true because : Equiamplitude surface of ground scraggly Pipe support above land not
regular Possibility to change / peripatetic
when landfill [by] ground or receives payload from the top monstrous.
Teknologi dan Rekayasa
A.Turns pipe
Teknologi dan Rekayasa
Joint that need to be given retainer :
B. Joint Knie 90
Teknologi dan Rekayasa
C. Tee Joint
Teknologi dan Rekayasa
D.Pipe connection final_
Teknologi dan Rekayasa
4 . Test pipe :
Step of putting down pipe :
a. Ground dug and in dig basis has plane equiamplitude surface.
b. Equiamplitude surface of dig has certain dip
Teknologi dan Rekayasa
c. Given sand as thick 10 cm
d. Pipe is put down, tied on correctness
e. Put down as according to above mentioned drawing.
Teknologi dan Rekayasa
Step of pipe test :
a. In check before hand every joint
b. By the end of pipe network is closed
Teknologi dan Rekayasa
c. At the end of pipe network attributed to pump
d. Depressed until pipe dividing valve permitted
e. Emphasis within 15 second/ 100 m. Pipe length.
Teknologi dan Rekayasa
Pipe test scheme
Teknologi dan Rekayasa
THE END
Teknologi dan Rekayasa