PE3608 & PE4710
-
Upload
pratik-ray-chaudhury -
Category
Documents
-
view
214 -
download
0
Transcript of PE3608 & PE4710
-
8/18/2019 PE3608 & PE4710
1/2
-
8/18/2019 PE3608 & PE4710
2/2
www.performancepipe.com
Bulletin PP681‐4710 September 2009
© Chevron Phillips Chemical Company LP
Performance Pipe, a division of Chevron Phillips Chemical Company LP 5085 W. Park Blvd Suite 500 Plano, TX 75093 Phone: 800‐527‐0662 Fax: 972‐599‐7348
DRISCOPLEX
®
64
PE471 HDPE PIPE
The following chart provides maximum recommended working pressures for PE 4710/3408 pipes &fittings for Water, Brine, and Dry Natural Gas Gathering service at the indicated operating temperatures.
Operating Temperature ( p sig )
73°F 100°F 120°F 140°F
403 314 254 202
336 262 212 168
252 197 159 126
202 158 127 101
126 98 79 63
101 79 64 51
6
7
9
11
17
21
Pressure Rating Vs Temperature
Design (Working) Pressures for Water, Brine and Dry Natural Gas Gathering service(Class 1, Class 2 and non-Federally Regulated Areas)
P i p e D R
1. Design (Working) Pressures are calculated in accor-dance with API 15LE specification. A check should bemade to determine if these pressures meet state and/orlocal codes
2. PE 4710 pipes with different outside diameter, but thesame DR have the same Design (Working) PressureRatings.
3. Minimum pipe wall thickness is determined by dividingthe pipe average outside diameter (O.D.) by the DRnumber.
4. Meets or exceeds requirements of API 15LE, ASTM
D2513 and PPI TR-4 Material Designation CodePE4710.
5. ASTM D3350, Cell Classification PE445474C