RUNNING BOARD FOR KIA

Part#PW003528

NOTICE:

Please read the instruction completely for easy installation, which will also help you to avoid scratches or other potential damages to your appealing car.Please periodically check and retighten all the hardware and clean the investment for a refresh look.

The figures here are for reference only and may have differences with the actual product you received, however they share the same assembly way.

Page 1 of 7

INSTALLATION INSTRUCTION

PARTS LIST:

No. No. Qty Qty Name Name

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

2

2

2

2

6

6

6

6

Running board

Front bracket

Rear bracket

middle bracket

T bolt M10

Hex bolt M10x25

Spring washerD10

Enlarger washerD10

Page 2 of 7

INSTALLATION INSTRUCTION

2

tine Hex bolt

Installation picture

ASSEMBLY PROCEDURE:Step 1: Check all the contents are available in accordance with the above list.Step 2: Remove the protect plastic in vechicle bottom.

Fig1

Running board bolts

1

2

4

3

2

6 7 85

6 7 85

9

Factory bolts

Page 3 of 7

INSTALLATION INSTRUCTION

Running board bolts

Running board bolts

Step 5: Install the Rear bracket in vehicle bottom,do not tighten all the bolts. (Installation picture,fig4)

Step 3: Remove the original rubber in vechicle bottom.

Step 4: Install the T bolt M10 in vehicle bottom

Fig2

Fig3

Fig4

Page 4 of 7

INSTALLATION INSTRUCTION

Fig7

Fig6

Fig5

Page 5 of 7

INSTALLATION INSTRUCTION

Step 6:Install the currency bolt M10 in vehicle bottom.(fig5)

Step 7:Install the currency bolt M10 in vehicle bottom.(Installation, fig6)

Step 8:Use tine Hex bolt,Install the Front bracket in vehicle bottom.(fig6)

Fig9

Fig8

Fig10

Page 6 of 7

INSTALLATION INSTRUCTION

Step 9:Remove the bolt in vehicle bottom,and then install the middle bracket.( Installation picture,fig8) .

Step 10:Remove the bolt in vehicle bottom,and then install the middle bracket.( Installation picture,fig9) .

Step 11:Use the Running board bolts,Install the Running board on bracket.do not tighten all the bolts( fig10) .

NOTE:Any damages and losses caused by improper installation and application, goes beyond our quality warranty.

Page 7 of 7

INSTALLATION INSTRUCTION

Step 11：Line up the running board with the brackets; finally follow up with tightening the bolts.

Step 12：Verify that all the hardware was installed and fully tightened.

Step 14：Repeat the step for other side running board.

Step 13：Install the fig1 protect plastic in the vehicle.

Step 15：Installation is finished.