Paran Sled Control Config a Rations
-
Upload
amitabh-sharma -
Category
Documents
-
view
215 -
download
0
Transcript of Paran Sled Control Config a Rations
-
7/21/2019 Paran Sled Control Config a Rations
1/2
Parans L2 Hybrid, configurations for controlling LEDParans L2 Hybrid LED component consist of a series of LED strips, which is fed by a Talexx powersupply unit, mounted on the the luminaire. If used with a dimmer or control systems such as DALI,DSI or similar, this power supply unit is exchanged.
Please consider the following specification in such a case.
Specifications
The LED component consumes 15 W.
The LED component supply voltage: 12VDC 5%, constant voltage. Constant current sources mustNEVER be used. Never connect the LED component with power supply on. Make sure mains poweris always interrupted when connecting/disconnecting the LED component. Always make sure polarityis correct from power supply to LED-strip. Reversed polarity will damage the LED componentbeyond repair.
The LED component can only be dimmed with a power supply unit that uses PWM (Pulse WidthModulation). PWM-frequency used should be 150Hz-20kHz.
Typical dimming scenarios
Typical dimming scenarios are shown below for i) Undimmed, ii) Switch dimmed, iii) DALI-controlled. Each case requires the correct power supply unit, delivering 12VDC output, and in case ofdimming has support for the actual dimming method required.
i) Undimmed configuration
ii) Switchdim configuration
iii) DALI configuration
-
7/21/2019 Paran Sled Control Config a Rations
2/2
Parans L2 Hybrid, configurations for controlling LEDSuggested DALI/DSI power supply unit
Product name: feno fd multi 1-24e
Producer: feno
14 L2 Hybrid luminaires can be connected to this driver. This power suppy unit replaces the Talexx
power supply unit mounted on each luminaire upon delivery.