7/27/2019 Pap2e, vol1

1/2

(1) During towing operations

a) Pilot must be in the cockpit to operate brakesb) A qualified person should be in the cockpit to operate brakes

c) A person should be in the cockpit to look for obstructions

d) Persons should be stationed at the nose and each of the wing-tips

(2) Tail-wheel type aero planes have the greatest tendency to move side-ways during

taxing when there isa) Cross wind

b) Tail wind

c) Head wind

d) None of these

(3) When parking a aircraft after towing, the nose wheel should be left

a) Pointed straight ahead

b) As it was when towing stoppedc) Unlocked

d) All are correct

(4) Before towing a large aircraft

a) Ballast should be put in the cockpitb) Tow bar should be fitted with a strong bolt

c) Tow bar should be fitted with a shear bolt

d) None of these

(5) The most commonly used driving tool by a mechanic is

a) Ball peen hammerb) Cross peen hammerc) Claw hammer

d) Sledge hammer

(6) While towing a large aircraft, personnel required are

a) Two in cockpit

b) As in a) plus one each on wing tips

c) As in b) plus one at the taild) As in c) plus one in overall control of operation

(7) I) Body hammers are used for driving stakes into the ground II) Sledge hammers areused for smoothing or stretching the metal

a) Only I) is correct

b) Only ii) is correctc) Both i) and ii) are correct

d) Neither i) nor ii) is correct

7/27/2019 Pap2e, vol1

2/2

(8) I) Body hammers are used for driving stakes into the ground II) Sledge hammers are

used for smoothing or stretching the metal

a) Only I) is correctb) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(9) I) Claw hammers are basically used for driving and pulling out II) The wedge of a

cross peen hammer is parallel to the handlea) Only i) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(10) A punch is used to

a) Mark a location

b) Remove a damaged rivetc) Locate a drill properly

d) AM are correct(11) i) A pin punch is used to remove the shank of the rivet from the hole after rivet head

has been chiselled off ii) Diameter of pin punch should be 1/64 inch smaller than the

diameter of the rivet to be removeda) Only I) is correct

b) Only ii) is correct

c) Both i) and ii) are correct

d) Neither i) nor ii) is correct

(12) i) Location given by a prick punch should always be punched later with a centre

punch. ii) Goggles must be used while using any type of punch.a) Only i) is correct

b) Only ii) is correct

c) Both I) and ii) are correctd) Neither i) nor ii) is correct

(13) . I) A mushroom head on a punch is better than a crown head since chances of

hammer slip are reduced II) A centre punch can be used for a variety of punchingapplications

a) Only i) is correct

b) Only ii) is correctc) Both i) and ii) are correct

d) Neither I) nor ii) is correct

(14)Most commonly used slip joint plier has a length of

a) 4 inches

b) 6 inches

c) 10 inches