pallet racking-2-

14
PALLET RACKING INTRODUCTION

Transcript of pallet racking-2-

Page 1: pallet racking-2-

PALLET RACKING INTRODUCTION

Page 2: pallet racking-2-

Selective Pallet Racking is a cost effective storage system providing direct access to all pallets . It provides high capacity storage , is easily installed and Adjusted , and has low equipment and capital costs.

• Rapid handling of almost all types of palletised goods

• Pallets can be located , accessed and moved individually

• Maximises space use in any warehouse configuration while retaining optimum product accessibility

• Bottom level pallets can be stored on the floor, lowering structure costs

Page 3: pallet racking-2-

Safety Lock

Box Beam

Pallet Support Bar

Steel Decking Panel

Colum Guard

Comer Guard

Base Plate

Plywood

Pallet Back Stopper

Upright

Mesh Decking Panel

Row Spacer

Barrier

Page 4: pallet racking-2-

Compatible to Dexion Brand Pallet Racking(50/75/76.2 Pitch adjustment)

Uprights Section Size Available As Below:90*70mm(1.8/2.0/2.3),100*70mm(2.0/2.3/2.5)Height : All sizes available in 50/75/76.2 pitch.

Box Beams Section Size Available As Below Height:80mm/90mm/100mm/120mm/140mm/150mm/160mmWidth :40mm/50mmLength : All sizes available.

1UPRIGHT&BEAM

Page 5: pallet racking-2-

Aceally upright specificatin

Page 6: pallet racking-2-

Aceally Beam specificatin

Page 7: pallet racking-2-

Aceally Distributed Loading Table

Page 8: pallet racking-2-

Each beam supplied with steel safety lock , which guarantee the beams correctly positioned and help prevent the beam being accidentally dislodged during this work.

3-hooks End connector Teardrop connector

SAFETY PIN

2BEAM CONNECTOR&SAFETY PIN

Page 9: pallet racking-2-

90/100 Frame Bracing 120 Frame Bracing

Bracing Block HorizontalChannel bracing(HB)

DiagonalChannel bracing(DB)

3BRACING

Page 10: pallet racking-2-

Row Spacers are fitted between frames of double entry racks to increase front to Back rigidity and stability.Length: As requiredSize: 50*30*1.5mm , rectangle pipe with endplates

Double Sides

Single Side

4SPACER

Page 11: pallet racking-2-

The Base Plate must be fitted to every upright to:u Provide a smooth bearing surface for the uprightu Spread the load of the upright over a reasonable area of floor

There are four common Base Plates in use for different situations:

5BASE PLATE&SHIM

Page 12: pallet racking-2-

U type upright protector L type upright protector Frame protector

Any damage to racking will reduce its load carrying capacity. Aceally provides a range of rack protection Accessories, include upright protector and frame protector.

6UPRIGHT PROTECTOR&FRAME PRTECYOR

Page 13: pallet racking-2-

Supported at each end by the beams, Pallet support beams provide a secondarySupport member for pallet racking or shelving . The Pallet Support Bar is designedto have its top surface approximately flush with the beams.

7PALLET SUPPORT BAR

Page 14: pallet racking-2-

Aceally Projects