8/9/2019 Origami Lily Print

1/1

www.origami-fun.com

Origami Lily

Instructions

1. St art with your papercoloured side up.

Fold in half, then in halfagain, as shown. Creasewell, then open out again.

2. Turn the paper over andfold in half diagonally and inboth directions. Crease welland open out once again.

3. Holding the points shown, bringthem both down to the centre pointon the bottom line and flatten.

4. Fold the top triangle into the centreand unfold. Usi ng this crease, openout the triangle and flatten.

5. Youll need to repeat step4 on all four of the flaps ofthe waterbomb base. Themodel will now look like this.

6. On the uppermost diamond,fold the outside corners into thecentre line, crease well then open.

7. Fold the model in halfand open. 8. Using the creases made in step 6 and 7, lift the

bottom point of the model (the uppermost layeronly) up to the top point, bringing in the sides ofthe model at the same t ime, as shown.

9. Repeat steps 6, 7 and8 on each if the foursides. The model shouldnow look like this.

10. Now fold downeach of thesetriangles, on allfour sides.

11. Rotate modelupside down.

12. Fold the outer flapstoward the centre andflatten.

13. Repeat step 12 on allfour sides of the model.The model should nowlook like this.

diagram is

enlarged

14. Fold down all petals.Completed Lily!