Installation ProcessPrecautionsTools for InstallationOverview of Cables1. Introduction to the OptiX OSN 3500 Equipment1.1 Exterior of the OptiX OSN 3500 Enhanced Subrack (2300 W)1.2 Exterior of the OptiX OSN 3500 General Subrack

2. Installing the Assemblies2.1 Positions of Installation Holes2.2 Installing the Cable Distribution Plate2.3 Installing the Fiber Management Tray2.4 Installing the SS61COA2.5 Installing the SS62COA2.6 Installing the RPC Frame

3. Installing and Routing Cables3.1 Cable Holes on the Top and at the Bottom of the N63E Cabinet3.2 Installing and Routing Power Cables and PGND Cables3.3 Installing and Routing Indicator Cables for the Cabinet3.4 Installing and Routing Alarm Cables3.5 Installing and Routing E1/T1 Cables3.6 Installing and Routing E3/T3/E4/STM-1 Cables3.7 Installing and Routing Ethernet Cables3.8 Installing and Routing IF Cables3.9 Installing and Routing External Clock Cables3.10 Installing and Routing Network Management Cables3.11 Installing and Routing Extension Subrack Cables

4. Installing and Routing Optical Fibers4.1 Installing and Routing External Optical Fibers4.2 Installing and Routing Internal Optical Fibers

5. Installing the Orderwire Phone5.1 Assembling the Base of the Orderwire Phone5.2 Installing the Orderwire Phone

6. Checking the Installation6.1 Checking Installation Effectiveness6.2 Checking Equipment Prior to Powering Up

7. Checking Optical Fiber Attenuation8. Engineering Labels8.1 Affixing Labels8.2 Common Engineering Labels

9. Assembling Cable Connectors9.1 Assembling OT Terminals and Power Cables9.2 Assembling the Cord End Terminals and Power Cables