Open-source NSE Codes Applied to 40 Gbit/s Soliton Lines
-
Upload
ryan-shepherd -
Category
Documents
-
view
46 -
download
0
description
Transcript of Open-source NSE Codes Applied to 40 Gbit/s Soliton Lines
Open-source NSE Codes Applied to 40 Gbit/s Soliton Lines
KAZUHIRO SHIMOURA
Kansai Electric Power Co., JapanECOC2001
( Oct. 4, 2001 RAI Congress Centre, Amsterdam,The Netherlands )
CONTENTSCONTENTS
Q-map method and Open-source CodeSimulation Reference System
40 Gbit/s Soliton line design by Q-mapsOptimal strength of dispersion management
Average-dispersion and signal-power design
Merit of the 40 Gbit/s soliton system
Nonlinear Schrödinger EquationNonlinear Schrödinger Equation
( by Akira Hasegawa 1973 )( by Akira Hasegawa 1973 )
][ BAz
])1(2
[exp),0(2
0
2
CiTS
Pm
26
1
2 3
3
32
2
2
iA
][2
22
RTi
B
Chirped Gaussian Pulse
Non Linear
Linear
Split Step Fourier MethodSplit Step Fourier Method ( by Fred Tappert 1971 )( by Fred Tappert 1971 )
Calculated by Mathematica Ver.4 on Win2000
Dispersion map of the simulation modelDispersion map of the simulation model (Periodical dispersion compensation scheme)
Pulse widths vibration in the DM-linesPulse widths vibration in the DM-lines ( 40Gbit/s, Dc=±20ps/nm, Lc=100km, with 6nm filters )
Global Structure Local Structure
Q-maps for the 40 Gbit/s DM-Soliton Lines
(Nc = 2, Pav=+5dBm, La = 50 km, Lt = 3 Mm)
Optimal Dispersion Compensation: Dc = ±30 ps/nm
Dav – Dc plane Dav – Pav plane
Nc = 4 Nc = 6
Q-maps for the 40 Gbit/s DM-Soliton Lines
(Nc = 4/6, Pav=+5dBm, La = 50 km, Lt = 3 Mm)
Optimal Dispersion Compensation: Dc = ±30 ps/nm
La=30km La=80km
Q-maps for the 40 Gbit/s DM-Soliton Lines
(Nc = 2, Pav=+5dBm, La = 30/80 km, Lt = 3 Mm)
La=30km La=80km
Q-maps for the 40 Gbit/s DM-Soliton Lines
(Nc = 2, Pav=+5dBm, La = 30/80 km, Lt = 3 Mm)
PMD = 0.1 ps/km0.5
PMD suppression effect of soliton
(Nc = 2, Pav=+5dBm, Dc=+30ps/nm, La = 50km, Lt = 3Mm)
PMD = 0 ps/km0.5
Optimal S-parameter for the DM-lineOptimal S-parameter for the DM-line( T. Yu, et. al., 1997 )( T. Yu, et. al., 1997 )
22
2211 55.2SS T
Dc
t
zkzkS
k = − ( λ2 / 2πc ) d = 1.27 D (ps/nm/km)
Ts (ps) : FWHM at chirp-free point
Dc = ±30 ps/nm, Ts = 6.8 ps S = 1.65
S = 1.65 ( T. Yu, et. al., 1997 )
Results of the 40Gbit/s simulationResults of the 40Gbit/s simulation
Dispersion management strengthDc = ±30 ±10 (ps/nm)
: for all cases S = 1.65
Signal Power and Dispersion Dav = +0.04 ± 0.02 (ps/nm/km)
Pav = +7 ± 2 (dBm) : for La = 50km case
Experimental setup of the 80 Gbit/s, Experimental setup of the 80 Gbit/s, 800 km transmission800 km transmission
MLLD LN
→10 40GMUX
10G(215-1)
Delay
PBSCoupler
80G
DSF
DCF
EDFA14APC
PBS
80G
PD
40G
40G PLL
EA1 EA2
20G 10G
80G 10G
10GReceiver
EDFA2
SPAN 1
EDFA1
SPAN 2
EDFA3
SPAN12
EDFA13
DSF
NZ-DSF
DCF
10G
Bit Error Rate for 8*10Gbit/s CHBit Error Rate for 8*10Gbit/s CH
–19 –18 –17 –16 –15
Received Power (dBm)
Bit E
rror
Rate
10–11
10–10
10–9
10–8
10–7
10–6
10–5
● : CH1■: CH2▲ : CH3▼ : CH4○ : CH5□: CH6△ : CH7▽ : CH8
Merit of the soliton-based systemMerit of the soliton-based system
For Long distance transmission
(Soliton stability effect, High intensity signal and suppressing PMD effect)
Conventional DSF without any dispersion slope compensation (Single Wavelength)
Narrow band low cost amplifier with Band pass filter is available.
Dispersion design is simple (Dc= ±30ps/nm)
Low cost High capacity system is possible.